Sponsored
Ducati1098's latest activity
-
Ducati1098 replied to the thread TPMS Module not picking up sensor.Hereās everything from the description and operation section of the workshop manual: TPMS Function NOTE: When directed to train any... -
@Ducati1098 rotate the tires, pull the battery and the drivers rear doesn't read after reset. Lost it while driving on the freeway in...
-
Ducati1098 replied to the thread TPMS Module not picking up sensor.Could be RFI maybe? Hard to say. The RTM receives the signal from the sensors, then communications all the information to the BCM. But...
-
Ducati1098 replied to the thread Raptor or Filson?.Theyāre most likely not dropping the 2.7 until after 2027
-
Ducati1098 replied to the thread TPMS Module not picking up sensor.TPMS uses the RTM (radio transceiver module) Itās at the very rear/top of the roll bar under the trim:
-
-
After more calling around it has to do with SCT, TDN etc. communicating with the 26.. left an email with ZFG, they have a good rep as...
-
Ducati1098 replied to the thread Anyone tuning a 2026 2.7.All the well known tuners list 2026, so Iām not sure why they wouldnāt be able to. For example: ZFG
-
You havenāt just watched from the sidelines-youāre part of the circle that has helped us. I know Iām probably going to miss someone but... -
List of mods: 32 spline UD44 with 4.56 gearing Werewolf portals Custom 8ā coilovers from Rock Krawler up front tuned for the portals and...
-
Ducati1098 replied to the thread Procal Tune versions changes.Itās all by build date. Newer updates donāt necessarily change the way the auto/start stop function works on every Bronco. Iāve...
-
Ducati1098 replied to the thread Manual transmission scraping noise / grinding sound.That is one number. There is another newer one though. The price is usually only that cheap when they're in the process of supersession.
-
Ducati1098 replied to the thread Recall 26S55: 2021-2026 Bronco - Engine Compartment Wiring Harness Repair [July 23, 2026] -- 590,000k units affected.There is no ETA at this time.
-
Ducati1098 replied to the thread Bronco Pickup Truck coming in future. Hybrid Bronco arrives 2027.lol drink! š» Very very few people likely have any inside information. Anything most people say, especially a dealer IMO, should be...
-
Ducati1098 replied to the thread SES - Emissions Control Sensor rich.MB3Z-9G444-D is the correct part number.
-
Ducati1098 reacted to userdude's post in the thread Acceleration of 2dr 2.3L Sasquatch vs 4dr 2.7 L Sasquatch ? with
Like.
Oh, I didn't catch it was a 2dr vs 4dr. Imeen, the only right answer is 2dr, but I digress... š -
Ducati1098 replied to the thread Acceleration of 2dr 2.3L Sasquatch vs 4dr 2.7 L Sasquatch ?.2.3 is going to be roughly ~1 second slower 0-60 for similar transmissions and packages. Door count doesn't really make that big of a...
-
Ducati1098 replied to the thread Bronco Badlands AC intermittent.In the direct message you sent me, you said it was a 2.7 On a 2.7, everything is on the drivers side, not the passengers side. I never...
-
-
Ducati1098 replied to the thread Bronco Badlands AC intermittent.The only switch is the pressure transducer, which is on the high side line right by the compressor. You can see it in that second...
-
Ducati1098 replied to the thread Lincoln To Get Bronco-Based Range Rover-Fighter.Agreed. And I almost guarantee itāll be the latter
-
Ducati1098 reacted to widnere12's post in the thread FINALLY... BACK IN THE COOL KIDS CLUB!!!! with Like.
For a trip back in history, on July 13th 2020, I happily put in my reservation for one of the first all new 6th Gen Broncos. I knew I'd...
-
Ducati1098, thanks so much. Great photos and descriptions.:clap:
-
Ducati1098 reacted to HotdogThud's post in the thread Bronco Pickup Truck coming in future. Hybrid Bronco arrives 2027 with Haha.
It's gonna happen bro! And it's gonna have a coyote V8 and both hookers AND blackjack! It'll come from the factory with 38's, and won't...
-
Ducati1098 replied to the thread Bronco Badlands AC intermittent.Low side: Drivers side, back of the engine to the right of the valve cover. High side: front of the engine, drivers side, right behind...
-
-
Ducati1098 reacted to Steve_In_29's post in the thread Bronco Pickup Truck coming in future. Hybrid Bronco arrives 2027 with Like.
A Bronco pick up would cut into Ranger sales not the F150.
-
Ducati1098 reacted to GoHawks63's post in the thread Lincoln To Get Bronco-Based Range Rover-Fighter with Like.
Agree. They need to differentiate it enough to not make it look like a dressed-up Bronco with an inflated MSRP. Lexus was able to pull...
-
Ducati1098 reacted to crenca's post in the thread Lincoln To Get Bronco-Based Range Rover-Fighter with Like.
I was thinking the same. Only thing I would tweak on that rendering is I don't think it will have that much clearance.
-
Ducati1098 replied to the thread Fender flare recall.Yes, all four according to the NHTSA report. Ford will normally pay or reimburse you for PPF through the recall. Cant say for sure it...
-
Ducati1098 replied to the thread 2026 Braptor Side Mirror Question.Is it possible the dealer just stuck that thing on there?
-
Ducati1098 replied to the thread Need Ford Help Dealer Recall Issue.Technical instructions are posted here...
-
Ducati1098 reacted to userdude's post in the thread Transmission Failure: ā24 32k mi 2.3l with Haha.
Nothing a little night visit with a little hammer won't fix. "Hey George, you hear pinging next door at the dealership??" "Go back to...
-
Ducati1098 replied to the thread Transmission Failure: ā24 32k mi 2.3l.LTIS is low time in service. It basically lets dealers simply replace the transmission without digging into it if diagnosis leads to an...
-
Ducati1098 replied to the thread Transmission Failure: ā24 32k mi 2.3l.10R60 failures are pretty rare. Are you over 3 years? I'm assuming you aren't. Not sure why they're even opening it up if it's still...
-
Ducati1098 reacted to RagnarKon's post in the thread Bronco Pickup Truck coming in future. Hybrid Bronco arrives 2027 with Haha.
Not the right forum for this but I CAN'T WAIT to go visit the Mustang forums today.
-
Ducati1098 reacted to VirginiaHeritage's post in the thread New recall (26V236)? POSSIBLE THAT THE TRANSMISSION OUTPUT SHAFT SPLINES OR TRANSFER CASE INPUT SHAFT SPLINES HAVE BECOME WORN OR DAMAGED with Haha.
Thanks. It would be a shame if I had no chance of getting another nice road photo of my Bronco from a sheriffās department.
-
Ducati1098 replied to the thread Lincoln To Get Bronco-Based Range Rover-Fighter.I think a lot of people expect something closer to the look of the Bronco. But I mean that's exactly what I would expect a "Lincoln...
-
Ducati1098 replied to the thread Bronco Pickup Truck coming in future. Hybrid Bronco arrives 2027.Yeah because I'm sure he's never said anything that hasn't actually happened. Maybe it will, but I wouldn't hold my breath.
-
Ducati1098 replied to the thread Bronco Pickup Truck coming in future. Hybrid Bronco arrives 2027.I'll believe it when it happens. This should probably be moved to the bronco pickup section also where all the other rumors are that...
-
Ducati1098 replied to the thread New recall (26V236)? POSSIBLE THAT THE TRANSMISSION OUTPUT SHAFT SPLINES OR TRANSFER CASE INPUT SHAFT SPLINES HAVE BECOME WORN OR DAMAGED.No need to worry about any break in
-
Ducati1098 reacted to prayers1's post in the thread M210 did I get the right CV Axle, Rebuilder Bronco with Like.
SUCCESS!!! Using the 13.5 worked. I wonder why if I have a M210 I use the shorter shaft. I guess Ford only knows. I truly appreciate all...
-
Ducati1098 reacted to VirginiaHeritage's post in the thread Warranty? Ford dealer said wonāt cover bc rusted with Like.
Look, it sucks. We can all sympathize. You let someone you thought was qualified do some work, and things went bad. But it wasnāt a Ford...
-
That was me - My dealer just replaced the clips and for now, the fender flare is secure. The work was done under warranty so no charge...
-
Ducati1098 reacted to huey's post in the thread New recall (26V236)? POSSIBLE THAT THE TRANSMISSION OUTPUT SHAFT SPLINES OR TRANSFER CASE INPUT SHAFT SPLINES HAVE BECOME WORN OR DAMAGED with Like.
thx for confirming and being the voice of reason @Ducati1098 - if I'm being honest I knew that already but I was hoping for something...
-
Ducati1098 reacted to prayers1's post in the thread M210 did I get the right CV Axle, Rebuilder Bronco with Like.
One Iād have to say is that I appreciate you responding back so fast, because I really have no one to discuss this with. Thank you! I...
-
Ducati1098 replied to the thread New recall (26V236)? POSSIBLE THAT THE TRANSMISSION OUTPUT SHAFT SPLINES OR TRANSFER CASE INPUT SHAFT SPLINES HAVE BECOME WORN OR DAMAGED.The only way damage would be done to the splines, is if there is a gap (loose bolt) which is why they use that to detect if it...
-
Ducati1098 replied to the thread M210 did I get the right CV Axle, Rebuilder Bronco.Like I explained above, 13.5" is probably correct and you got the incorrect shaft in the correct box. This also explains why the...
-
Ducati1098 replied to the thread M210 did I get the right CV Axle, Rebuilder Bronco.Only thing that makes sense at this point is that the intermediate shaft you got was boxed incorrectly. It's honestly not that uncommon...
-
Ah Ducati wins again - those were the threads I was remembering but i only recalled fhe titles I guezs
-
Thank you sir.
-
Ducati1098 replied to the thread M210 did I get the right CV Axle, Rebuilder Bronco.I think it's just implied that the circlip needs to lock into the housing. Either way, there's only one way to check if it's in all the...
-
Ducati1098 replied to the thread Rear Lower Link Bolt Size?.Yep, M16 and 112mm long
