I’ve downloaded and installed 4 versions. Started with latest beta, then saw a post somewhere that said try an earlier version. Those couldn’t communicate with the PCM so I wasn’t able to try anything with them. The lates beta is back on my laptop. I’ve tried multiple profiles multiple times.
Getting the same error when trying to update IPC. Will try creating a new profile today.
I tried it all. Nadda. My last resort was to write back to stock and start over.
Ok, so I also found a YouTube video by Colts Way. very informative and cut my anxiety way down. Got rid of the double honk and tested it. Then changed the tire diameter. Thinking I was done, I forgot to hit the disconnect button in forscan, and pulled the cord out. Now, I get two errors on the bronco dash screen, “check 4x4” and “service vehicle soon”. Also, Forscan doesn’t recognize the connector anymore, so I can’t disconnect properly to see if I can get the errors to clear.
Any luck with your issue? I did some changes last night and noticed today I have same issues you described plus the radio is all messed up and doesn’t work, I did disconnect before pulling the cable.
Yup. Same problem. Sometimes it’s the left front window and other times the right front one. Have not found a solution but haven’t really tied either.
Noticed it was driver only once, then both fronts the second time I tried it.
This is just a general issue with the Bronco unfortunately. I believe it's why they didn't program Global Close from the factory. Not sure if it has to do with the power draw through the quick detach socket or what but even if you try to roll all four up manually it can sometimes be finicky.
Sorry, what module is that?
Sorry was in a rush to push the suggestion, that's in the APIM (Sync). This will (in theory) remove the navigation pane from the side screen (IoD). Not seeing much in the form of other suggestions to eliminate connected navigation nuisances in the quick look I took.
Looks like it's successful after module flash and reset. Thanks!
