Search results

At least I have never heard of this issue. I used the lower control arm removal method and took care not to over extend the axle that I have heard is the biggest issue with this approach. I strapped the back of the knuckle to the frame to make sure the axle would not over extend. The strap...

I am pretty sure I read somewhere about a way to leave the transmission in neutral with the engine off without the chime sounding for long time. I don't remember where I saw it or the instructions. I have a lift and like to leave the transmission in neutral so I can push my Bronco back and...

I want to install my ham radio above the windshield on the passenger side. My concern is routing the coaxial cable through the A pillar. Can this be done without interfering with the air bag stashed in there? I don't know if I can remove the plastic covering there. I certainly don't want to...

I have installed my single brushless onboard air compressor. I installed the trigger wire directly to the AUX 6 switch without the ARB isolation switch. It works very well. However, I discovered the internal fan in the compressor continues to run (with the compressor off) after running the...

I would like to know if the oil port sensor is before or after the oil filter. I am going to be doing some work in that port with the sensor off and would like to know how careful I should be about getting any debris in there. I know I should be careful anyway but if it goes directly to the...

Is it normal to have a small amount of heat come out out of the dash vents when I have only the floor vents on? It is not blowing hard out of the dash but I still have to turn the vents away from me because it feels uncomfortable. I have the manual control HVAC system. I am leery of taking...

I have been researching option for mounting an on board ARB single brushless compressor. The engine compartment is my preference. I have found a mount that I like offered by JCR Off-Road. It looks like it meets my needs but I would like information from anyone that has some experience with...

I want to lift my engine compartment fuse box to figure out how I can mount a bracket under or near it to mount an oil bypass filter behind it. I have searched online for a video to help but came up with nothing. I can't find any information in my Ford Service manual either. Does anyone have...

On my way to work this morning, my windshield had a hard impact as I was driving 80 mph. I did not see what hit it but there was a loud pop that startled me. I immediately looked to see the damage but could not find any. Later, I discovered scrape marks on the windshield. It must have been a...

I want front floor mats for my Badlands but can only find a complete set for front and rear seats. I have taken out the rear seats and do not need the rear floor mats. I prefer OEM non-carpet mats because I like how they lock in place. Carpet mats came with it when I bought new, but they...

I am trying to figure out what thread is on the nut insert that is on top of the dash to be used for accessories. I tried a M6-1.0 bolt and it started okay but stopped after a couple turns. I am guessing it is a M6-1.25 thread. I did a search and found many are using a 1/4-20 bolt. That is...

I have read in several threads online that lift is achieved by preloading the springs and that causes the springs to be stiffer. I may be misunderstanding but I have the Eibach Pro 2.0 coil over kit that has adjustable lift. I have not installed them yet but have been studying them to...

I have not had many vehicles with an automatic but the ones I had/have shift pretty quick at full throttle. Today, for the first time, I hit full throttle after starting to roll and let it go to a little over 70 mph. I was shocked how much lag there is during each shift. It is like the engine...

I ordered the Bronco USB Workshop Manual from Helm shortly after I bought my 24 Bronco in November. I have used it a couple times and it has been very helpful for the most part. I recently decided to check out the Engine Diagnosis and Testing section. I went through all the steps too get to...

I heard it mentioned in a video online that Ford spec oil may need to be used in engines with wet belts like in our 2.7L Ecoboost engines to drive the oil pump to get longer life out of the belt. That is the first time I have heard anything like that. Is that real or just speculation?

My Bronco is going in to the dealer on Friday to determine what is wrong with it. I have not had a chance to see if it threw a code but I am sure it did. I searched this website to see if anyone has experienced what I did and I found nothing about it.. Last evening when coming home from work...

I plan to use the space under the hood that is normally used for a compressor for something else. I have found a place inside the frame below the passenger seat area that looks like a good area for an air compressor. I have seen air compressor mounted under vehicles before that seem to work...

When I was looking to buy a 2024 Badlands, I looked at a couple that had removable hoop steps on the rock sliders. I ended up buying a Badlands without the hoop steps. I have decided I would like to have them but can't seem to find how to obtain them. Are they only available from the factory...

It seems the factory battery in my Badlands is marginal for how I intend to use it. I have gotten suggestions which include adding another battery but I don't think I want to go that route for various reasons. My preference is to install a battery with more CCA and capacity. I have gotten...

I have been working with my solar for charging when in remote wilderness to keep my refrigerator running, This is the first time I have taken a good look at the battery in my Bronco. The negative post looks like it would work on another battery but I am not sure the positive post is compatible...