SierraBronco's WildTrak Build

[87-Z28]

I wish I had some decent welding skills.

Sponsored

 

[SierraBronco]

I wish I had some decent welding skills.

Me too. Hence my dropping it off at a shop that will do a much better job than me. Especially when it comes to the pumpkin

 

[87-Z28]

Very curious how the 4 link rear and walker shocks on the front anti sway bar is gonna ride on the road. Keep rockin on.

 

[SierraBronco]

2.8 gallon tank installed to help the compressor out a bit. Waiting on the rear axle to be done to do any testing. (Disconnected battery before pulling axles so I didn’t need to worry about the brakes)

 

[SierraBronco]

Axle is back. Oil drained and new diff cover and skid plate installed. Branding removed and replaced with my own. Hate that these companies are getting so brazen that they’re welding their logos onto shit. But that’s what a grinder is for.

 

[SierraBronco]

Update on Rock Krawler triangulation kit:

https://www.bronco6g.com/forum/thre...on-install-test-and-review.90742/post-2209038

 

[SierraBronco]

Winch installed today. Also cut off the ends of the bumpers. Will relocate sensors into the fascia below the grill if there’s room. If not, no worried.

 

[SierraBronco]

Let there be light

 

[SierraBronco]

Reinstalled the sensors that were in the ends of the bumper. Just a little creativity with painters tape and a razor for the template then hit it with a Dremel

 

[coffeetwitch]

bumper chop looks good. whats the side shot look like?

 

[SierraBronco]

bumper chop looks good. whats the side shot look like?

I’ll getcha a picture. You want a close-up or include some fender and tire? What are ya looking for?

 

[coffeetwitch]

front corner. something that would show front right or front left corner. wondering if a plate would need to be welded on to chopped bumper to finish it off.

please and thank you

 

[SierraBronco]

front corner. something that would show front right or front left corner. wondering if a plate would need to be welded on to chopped bumper to finish it off.

It would certainly look a tad better compared to the hole that’s there.

 

[SierraBronco]

front corner. something that would show front right or front left corner. wondering if a plate would need to be welded on to chopped bumper to finish it off.

please and thank you

Here ya go

 

[coffeetwitch]

Not bad. wouldnt take much to cap it off, if a person wanted to.

Thank you

Sponsored