IPMA Cover Removal

[Xinnes88X]

I looked in the fourms and did not see anything on this. I want to remove the IPMA Cover above/behind my rearview mirror to run some wires underneath. Has anyone done this before? Should it just snap right off with a trim tool? TYIA

Sponsored

 

[flip]

Image Processing Module A (IPMA)
Special Tool(s) / General Equipment

Interior Trim Remover

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Using the interior trim remover release the tabs and remove the IPMA cover.
   Use the General Equipment: Interior Trim Remover

1. Disconnect the electrical connector.

1. 
   Remove the IPMA .
   1. Remove the upper tabs.
2. 1. Remove the lower tabs.

Installation

1. 
   Install the IPMA .
   1. Install the lower tabs.
2. 1. Install the upper tabs.

1. To install, reverse the removal procedure.

1. NOTE: This step is only necessary when installing a new component.
   • If a new IPMA has been installed, using a diagnostic scan tool, complete the PMI process for the IPMA following the on-screen instructions.
   • If a new IPMA has been installed, carry out the camera alignment using a scan tool.

 

[Brian_B]

Make sure the cable/harness in there get back in their clips correctly, otherwise they rattle like crazy and it sounds like it’s coming from the rear cargo area.

 

[murrman]

For anyone who has removed this cover, where did you start prying? I’ve been trying for the past few minutes, and can’t get it off. Should I start at the bottom or the sides?

 

[Ducati1098]

For anyone who has removed this cover, where did you start prying? I’ve been trying for the past few minutes, and can’t get it off. Should I start at the bottom or the sides?

I always go from the side. It just pops off pretty easily

 

[murrman]

I always go from the side. It just pops off pretty easily

Thanks, I ended up getting it. Starting at the top right worked best in the end.

Sponsored