Sponsored

Another “Rattle” Thread

First Name
Matthew
Joined
May 29, 2023
Threads
3
Messages
24
Reaction score
21
Location
NC
Vehicle(s)
Bronco
Your Bronco Model
Raptor
I have searched the forum and have listened to the videos but not certain any of the others are the same. This sound started conveniently the day after I purchased the vehicle.

It’s consistent once you get moving more than 12 mph and is not alleviated by any pressing of any part of the dash.

Any ideas?

Thanks in advance

Sponsored

 

Ford Motor Company

First Edition
Well-Known Member
Official Ford Account
First Name
Ford
Joined
May 25, 2021
Threads
17
Messages
6,908
Reaction score
8,270
Location
Dearborn
Vehicle(s)
Bronco, Bronco Sport
Your Bronco Model
First Edition
I have searched the forum and have listened to the videos but not certain any of the others are the same. This sound started conveniently the day after I purchased the vehicle.

It’s consistent once you get moving more than 12 mph and is not alleviated by any pressing of any part of the dash.

Any ideas?

Thanks in advance

Hi Matthew! I can look into your Bronco's noise concern on my end. To get started, could you please send a private message over with the name/location of your local Ford dealer and your Bronco's VIN?
 

Area51BS

Badlands
Well-Known Member
First Name
Ron
Joined
Sep 20, 2022
Threads
232
Messages
3,140
Reaction score
5,073
Location
Florida
Vehicle(s)
Badlands non SAS 4dr 2.3
Your Bronco Model
Badlands
That would drive me crazy. Start disassembling.
 

Smocaine

Badlands
Well-Known Member
Joined
Jul 26, 2024
Threads
6
Messages
623
Reaction score
1,646
Location
DFW, TX
Vehicle(s)
Cervelo Caledonia
Your Bronco Model
Badlands
Clubs
 
Long shot (because it's hard to tell where it's coming from through video, so you probably know better than me) but check under your vehicle first. I had some loose electrical tape on the harness running along the frame on the driver's side which produced a sound like an inconsistent rattle but it was actually the tape buzzing in the wind. I cut off the loose part and put some fresh tape over it.
Sponsored

 
 





Top