Mullet Bronco Build

[Snacktime]

@popo_patty Stickercon 2026 is going to epic, make sure to bring plenty of goo-gone.

@SierraBronco I am still surprised you haven't reworked the trailing arm setup yet. Might wheel better with less rear travel as it will have less rear steer and more control placing rear tires.

Sponsored

 

[popo_patty]

@popo_patty Stickercon 2026 is going to epic, make sure to bring plenty of goo-gone.

I should have purchased more stickers….

 

[SierraBronco]

@glo

@popo_patty Stickercon 2026 is going to epic, make sure to bring plenty of goo-gone.

@SierraBronco I am still surprised you haven't reworked the trailing arm setup yet. Might wheel better with less rear travel as it will have less rear steer and more control placing rear tires.

Nothing limit straps cant fix, but so far the rear steer hasn’t really been an issue. I actually just extended the limit straps to give additional droop and see what that’s like.

But I do want to get rid of the wishbone three link and go to a traditional three link with panhard bar.

 

[5GENIDN]

@glo


Nothing limit straps cant fix, but so far the rear steer hasn’t really been an issue. I actually just extended the limit straps to give additional droop and see what that’s like.

But I do want to get rid of the wishbone three link and go to a traditional three link with panhard bar.

If rear steer is not a problem I am curious as to why you want to change the wishbone to a traditional? what are you experiencing that would be different?

Do you think you are getting more lateral movement with the wishbone?

 

[Footer]

And that, my friends, is how you keep a marriage alive and never ending. Your efforts to support your wife physically, mentally, emotionally and materialistically are amazing !!

 

[Snacktime]

I actually just extended the limit straps to give additional droop and see what that’s like.

You need to watch how the vehicle acts as you load up the suspension while crawling. Short link allow the geometry to change making rear lift instead of squat. Nose down the rear suspension will uncompress making it very tippy. I think you already have experienced this on the previous setup.

 

[SierraBronco]

If rear steer is not a problem I am curious as to why you want to change the wishbone to a traditional? what are you experiencing that would be different?

Do you think you are getting more lateral movement with the wishbone?

You need to watch how the vehicle acts as you load up the suspension while crawling. Short link allow the geometry to change making rear lift instead of squat. Nose down the rear suspension will uncompress making it very tippy. I think you already have experienced this on the previous setup.

Looking at going to traditional three link as the wishbone is subjected to huge amounts of stress when wheeling.

And yeah, with the D44 the antisquat was pretty neutral and we didn’t have much lifting from the back under throttle. But going to D60 and lifting that third link connection and using the original OEM frame mounting locations put us above 100% and we now have lifting. Good for climbing, not as much for descents. Going to a conventional three link will give us the flexibility to fix that and get us back to neutral, reduce the axle steer, and put those lateral forces onto the panhard.

 

[SierraBronco]

@glowworm this is the thread I mentioned this morning. Nice meeting you!

Sponsored