Rust proofing using NEW PB Blaster Surface Shield & T9 -- DIY & Result Photos

[murrman]

Reviving this old thread because I hope to undercoat my Bronco this week using Surface Shield. I know it won't be as good of a job as going to a professional place, but I figure anything is better than nothing. Assuming I don't plan on removing anything before coating, are there any areas that I need to avoid coating? I plan on masking off the brakes, but I'm not sure if there's anything else I should worry about.

Sponsored

 

[Pops]

Reviving this old thread because I hope to undercoat my Bronco this week using Surface Shield. I know it won't be as good of a job as going to a professional place, but I figure anything is better than nothing. Assuming I don't plan on removing anything before coating, are there any areas that I need to avoid coating? I plan on masking off the brakes, but I'm not sure if there's anything else I should worry about.

YES this. I am in the same boat.
Also wondering about the front end alignment adjusting fasteners -- those look to be carefully masked off.

whatever those are called -- adjusto things. i are a engineeer.

tks!