What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠

[cynicalrider]

something thin yes but it sits pretty high up to the roof. It would be hard to access it without folding it down.

It looks like they probably could have made it bigger but were taking into account soft top lift. For my hard top with the tilt function it would have been cool to get those extra couple of inches.

Sponsored

 

[Aonarch]

Dropped it off at the dealer for the first time in my ownership.

My doors and windows have sucked since day 1.

The passenger door takes a lot of effort to open and close, but the body lines look good. So it isn't like the latch position or door position needs to be adjusted.

Then on Monday my drivers door finally sagged into the fender. I've been having problems with it for a few weeks where it sounded like it badly needed grease, or had worn out components.

Driver's door shut, Look at the alignment!

Barely opening the door puts it into the fender.

Weird passenger side dent that has been there since week 1?

I have the slow window roll down that a lot of you have. I asked the dealer to flash the module.

The windows grab every time you open the door. Then sometimes they will get out of sync and smash into the body.

I started opening the doors with two hands so I can pause and let the window roll down first.

 

[bkfit]

Ripped this out put this in, well 2days ago.

 

[PrepVet]

Dropped it off at service, hopefully in a few days I will get it back. As close to rattle free as these cars get. lol

 

[5GENIDN]

A little OEM+. Swapped the cover. Used all supplied hardware.

Just installed mine this weekend as well!

I like it for 4 reasons:
1) easy drain plug
2) magnet on drain plug
3) heavier casting that should improve strength across the housing
4) Looks awesome!

 

[WheresMyBronco]

Dropped it off at the dealer for the first time in my ownership.

My doors and windows have sucked since day 1.

The passenger door takes a lot of effort to open and close, but the body lines look good. So it isn't like the latch position or door position needs to be adjusted.

Then on Monday my drivers door finally sagged into the fender. I've been having problems with it for a few weeks where it sounded like it badly needed grease, or had worn out components.

Driver's door shut, Look at the alignment!

Barely opening the door puts it into the fender.

Weird passenger side dent that has been there since week 1?

I have the slow window roll down that a lot of you have. I asked the dealer to flash the module.

The windows grab every time you open the door. Then sometimes they will get out of sync and smash into the body.

I started opening the doors with two hands so I can pause and let the window roll down first.

Please keep me updated on the passenger door issue and what they do to fix it if possible. My passenger door takes more effort to open/close as well and I can't seem to figure it out, but I also don't want to take it in because I'm worried they'll ruin its alignment.

 

[Aonarch]

Please keep me updated on the passenger door issue and what they do to fix it if possible. My passenger door takes more effort to open/close as well and I can't seem to figure it out, but I also don't want to take it in because I'm worried they'll ruin its alignment.

Will do!

 

[Boreal]

I like it for 4 reasons:
1) easy drain plug
2) magnet on drain plug
3) heavier casting that should improve strength across the housing
4) Looks awesome!

6) Should aid in heat dissipation

Perks all around!

 

[Oldhippie]

Spent over an hour on the phone with ford engineer getting procal tune installed…this was the second day…nice guy and I am computer idiot but still pretty ridiculous…and not done yet…still have rack install and resetting speedo for 37s…

 

[IwannaGOfast]

Well Finally took delivery. A few minor hiccups but the wife is happy and that's what matters.

First hiccup was it has been at the dealership since Tuesday but my salesman was never told and he hadn't checked until I asked him about it yesterday. Second hiccup was the tow package. No one knew where it was until this morning. So installation will be scheduled in the near future. Third hiccup was during the test drive a trim piece fell off. Now that has to be ordered.

On the plus side I was pleasantly surprised I was able to get D plan price. When I asked the owners of the dealership before I ordered, one sent me to the other and that one wouldn't commit. He said we'll figure something out when it comes in.

Looks like Fairway Ford.

That's where I got mine from

 

[Philrod]

Looks like Fairway Ford.

That's where I got mine from

You are correct. I work at the sister store but like the sales people and managers at Fairway better.

 

[Noremac]

Did oil changes on both of our broncos, my 2.7 got the Ronin oil plug setup to do away with the yellow plastic BS... and did cabin air filters. surprisingly those were not as bad as i expected after 35,000 miles on each

 

[Southside_Ray]

I installed Heretic Studios fog lights. Took 8 weeks to arrive, but totally worth it!

 

[Durangatan]

Another shitty day on the ranch. No pavement / garage for this Bronco.

 

[SilverStreak02]

I technically didn’t do it, but I did pay to have my windows tinted. 50% all around except the front sides which are 20%.

Sponsored