Sasquatch before and after 35mm wheel spacers

[Trickster]

Very nice! So since the factory Sasquatch wheels I think are +35 I’m guessing you are now back to zero offset correct?

Sponsored

 

[Trickster]

I used 1.4" borne/mishimoto. Very similar results w/stock sas tires, when I switched to 37s I also used the beadlock rings, which, it is worth noting, moves the outboard sidewall outward by an inch or so, giving it just a little more "poke"

I think it looks good, and functionally on trails the sidewall is the widest part of the vehicle (but not excessively so)

 

[Bronco cat]

To improve off-road capabilities

And to make sure you sling more shit up the side of the car.

 

[ATLBronco75]

Hey guys I hate wheel bearings. What’s the best way to have to replace them early?

 

[Badassbronco]

I'm ignorant when it comes to wheels and such. Had you chosen to buy after market wheels, could you have achieved a similar result with wheels that had a different off-set? I'm still trying to understand all these technical terms.

Yes I could have but buying 5 wheels is much more expensive.

 

[Badassbronco]

Very nice! So since the factory Sasquatch wheels I think are +35 I’m guessing you are now back to zero offset correct?

I think factory is +30mm

 

[TTT]

<iframe width="560" height="315" src="https://www.youtube.com/embed/hWijfooeSyU" title="YouTube video player" frameborder="0" allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>

 

[AMK610]

Love this look. I’d probably get non sas fender flares to get the same look, rather than wheel spacers. But that’s why there’s chocolate and vanilla

 

[TXAG96]

Hey guys I hate wheel bearings. What’s the best way to have to replace them early?

 

[MWILD]

I thought about getting wheel spacers for long time, but decided in the end to swap out the sas flares for the normie ones… you get the same look without all of the wheel spacer headaches.

 

[M4Madness]

Hey guys I hate wheel bearings. What’s the best way to have to replace them early?

Ha! I know it's an apples to oranges comparison, but a guy at work put spacers on his Chevy truck and went through two sets of front wheel bearings in a year! Twice he was stranded on a 12-hour drive between states and had enormous tow bills. In no way am I saying that this will happen to a Bronco, but it's always in the back of my mind when I read about wheel spacers.

 

[Fmuguira]

Looks nice if you re into tire and flare being close. No right or wrong but I ll stick with factory as these things with SAS fling rocks, mud and everything all over even with the wide flares.

As mentioned offset is harder on wheel bearings; especially if you wheel extreme.

 

[rguest3]

+30mm Factory Sasquatch Wheel

35mm Spacer (-35mm)

-5mm Overall Offset

 

[SavSqch]

I have never been comfortable with spacers. I feel it puts to much on bearings etc. looks good but just isn’t for me.

Sponsored