Sponsored

Bronco Team 2 door.

Ford Motor Company

First Edition
Well-Known Member
Official Ford Account
First Name
Ford
Joined
May 25, 2021
Threads
17
Messages
6,913
Reaction score
8,271
Location
Dearborn
Vehicle(s)
Bronco, Bronco Sport
Your Bronco Model
First Edition
Took it out to Peek-a-Boo canyon just north of Kanab, UT. If you are ever in this area, this is a must see. You take a DEEP sand trail about a mile in with the Bronco. Don't forget to air down. It takes you right to the mouth of the slot canyon. The canyon goes about 1/3 mile in before it dead ends.
Trail 5.jpg
Trail 2.jpg
Trail 3.jpg
Trail 4.jpg
TRail 1.jpg
Wow! Thanks for sharing these awesome photos with us, Jim!
 

Sponsored

Dialtone

Big Bend
Well-Known Member
Joined
Jan 16, 2024
Threads
7
Messages
403
Reaction score
590
Location
Twilight Zone
Vehicle(s)
Bronco Big Bend Mid
Your Bronco Model
Big Bend
I tried that Turtle Wax Ceramic Spray Coating product, and it left my red car with lots of streaks. Mostly visible at an angle when the light reflected. I could not buff them out. Took a lot of time messing around with a damp cloth to cut through and get rid of the smearing. The cuss words were flying. Hard to tell how much product was left after all the work correcting the streaking.

I ended up instead buying some quality carnauba wax ... old school apply, wait until haze, and buff out. Worked great.

Do you have a trick to avoiding streaks with the TW Ceramic Spray?

Streaking issue mentioned here at the 3:56 mark:
Hot surface or too large a working area will streak up pretty quick on you. If wait for a flash and haze it's too lat hot too thick. Dark colors are a real challenge. I've worked the job on my black truck more than once. A wait and reapply can bail you out sometimes or a very fine swirl remover or clay bar. There's a reason a pro charge $$ I'm cheap so I accept screwing up until I get it right a part of the process.
 

Dialtone

Big Bend
Well-Known Member
Joined
Jan 16, 2024
Threads
7
Messages
403
Reaction score
590
Location
Twilight Zone
Vehicle(s)
Bronco Big Bend Mid
Your Bronco Model
Big Bend
I tried that Turtle Wax Ceramic Spray Coating product, and it left my red car with lots of streaks. Mostly visible at an angle when the light reflected. I could not buff them out. Took a lot of time messing around with a damp cloth to cut through and get rid of the smearing. The cuss words were flying. Hard to tell how much product was left after all the work correcting the streaking.

I ended up instead buying some quality carnauba wax ... old school apply, wait until haze, and buff out. Worked great.

Do you have a trick to avoiding streaks with the TW Ceramic Spray?

Streaking issue mentioned here at the 3:56 mark:
Good video. I use a battery powered leaf blower for the nooks and crannies to chase out water.
 

Sponsored

KRAKEN

Black Diamond
Well-Known Member
First Name
Andy
Joined
May 23, 2023
Threads
39
Messages
767
Reaction score
2,773
Location
North Alabama
Vehicle(s)
2023 2 DOOR BRONCO, 2014 F150 XLT, 2006 F150 FX4
Your Bronco Model
Black Diamond
Where did you get those Badlands sill guards?... they look good.
 

HeliPilot

Badlands
Well-Known Member
First Name
Kenny
Joined
Dec 17, 2021
Threads
20
Messages
1,691
Reaction score
3,586
Location
CT
Vehicle(s)
2022 2.7L SAS
Your Bronco Model
Badlands
They are Tuff Skinz. Found them on ETSY, but they are available elsewhere.
 
 





Top