You have the Bronco model and it bent, what did they say about that when you contacted them?
After having mine for several months I like it more than at install. As for that gap I made some short mud flaps to stop most of the mud flinging up through the gap.
No for whatever reason mine looks like this no matter what I do. That part doesn't bother me too much, at least it adds clearance.
That’s tilted pretty good. Mine isn’t like that. I had to fiddle with the bumper a LOT to level it out. However, one of the smaller side bolts broke off going in. I’m guessing some of the holes aren’t lined up properly due to poor QCNo for whatever reason mine looks like this no matter what I do. That part doesn't bother me too much, at least it adds clearance.
Yeah I tried it a few different ways. Thinking about slotting a hole.
I left out a bolt on each side that wanted to cause the tilt. I was able to get a good alignment. I’ll take a picture of the bolt I left out later and add it here in case you wanted to see.No for whatever reason mine looks like this no matter what I do. That part doesn't bother me too much, at least it adds clearance.
They have said they are replacing it with an upgraded model. Big it has been weeks. I also bought their tailgate support, and I'm pretty sure I'm just going to go back to that and figure out a different bumper set-up.
That’s crazy, the site says it supports a 40”. I hope they send you a new bumper.
Yeah, they have been very cool about the issue. They have since updated the design and just are waiting on the new inventory. But yeah, it says 40s. But the angle of the carrier on my tail says different. But it does look cool as f.
Got a link for that skid plate? Also, how are you liking the 4 Wheel Parts 61468W bumper? I just ordered one and just need to figure out the license plate mount.
It’s still available, just a lil more expensive than when I ordered - https://a.co/d/0c8HVT0q
Thanks for the link, just ordered the skid plate!! I meant the rear bumper btw, I'm keeping the oem plastic front bumper which I am protecting with the Steelcraft HD brush guard.It’s still available, just a lil more expensive than when I ordered - https://a.co/d/0c8HVT0q
I’m LOVING these bumpers. They do seem to chip a bit easy (I think the powder coat is cheap), but other than that, they’re awesome!! The winch mount makes the front install rather tedious, but so worth it IMO
Not too heavy, but both front and rear are strong and have not bent when dropping onto rocks or bumping into rocks or trees
I hit a deer at 45mph and the bumper could have cared less. There’s absolutely no damage on the bumper, didn’t even tweak the position of it. Cracked my grilled and valence panel, but that’s it
If I were building another Bronco, I would buy the exact same bumpers again (the deal is just too good to pass on), but with my 8112’s, I’d find a different skid plate set (because the front reservoirs are rather exposed)
I did IAG flare deletes and that really changed the look of the entire vehicle, with those bumpers
I’ve not installed a license plate on the front, so I’m of no help there. I’d think right below the winch mount would be the spot I’d choose
(pre-8112’s @ Badlands)
Oh, my bad, sorry, I had just rolled out of bed when I typed that upThanks for the link, just ordered the skid plate!! I meant the rear bumper btw, I'm keeping the oem plastic front bumper which I am protecting with the Steelcraft HD brush guard.
