You have the Bronco model and it bent, what did they say about that when you contacted them?
After having mine for several months I like it more than at install. As for that gap I made some short mud flaps to stop most of the mud flinging up through the gap.
No for whatever reason mine looks like this no matter what I do. That part doesn't bother me too much, at least it adds clearance.
That’s tilted pretty good. Mine isn’t like that. I had to fiddle with the bumper a LOT to level it out. However, one of the smaller side bolts broke off going in. I’m guessing some of the holes aren’t lined up properly due to poor QCNo for whatever reason mine looks like this no matter what I do. That part doesn't bother me too much, at least it adds clearance.
Yeah I tried it a few different ways. Thinking about slotting a hole.
I left out a bolt on each side that wanted to cause the tilt. I was able to get a good alignment. I’ll take a picture of the bolt I left out later and add it here in case you wanted to see.No for whatever reason mine looks like this no matter what I do. That part doesn't bother me too much, at least it adds clearance.
They have said they are replacing it with an upgraded model. Big it has been weeks. I also bought their tailgate support, and I'm pretty sure I'm just going to go back to that and figure out a different bumper set-up.
That’s crazy, the site says it supports a 40”. I hope they send you a new bumper.
Yeah, they have been very cool about the issue. They have since updated the design and just are waiting on the new inventory. But yeah, it says 40s. But the angle of the carrier on my tail says different. But it does look cool as f.
