The FP tune nu bers published are likely very conservatinve at best....Enhance the performance of the 2.3L EcoBoost engine in your 2025 Bronco. Ford Racing Parts calibrations are engineered and dyno tested to deliver increased power and performance while maintaining reliability.
--------------------------------------------------------------------------------------
- Peak Power = 333 hp @ 5,000 rpm
- Peak Torque = 415 lb-ft @ 3,500 rpm
- Improved throttle response throughout rpm range
- Optimized Shift Schedule for automatic transmission equipped vehicles
- Premium Fuel Required
- Ford Racing Parts 3 year/36k mile warranty from new vehicle in-service date when installed by a Ford dealer or ASE/Red Seal certified technician
- Ability to change tire size up to BFG 37x12.5R17 KO2 size (579 revolutions per mile) [Additional modifications required]
- Ability to change axle/FDU ratio up to 5.38
- Enables upgrade of M190 to M210 front drive unit by reconfiguring DLCM module
- For U.S. & Canadian Vehicles
- For non-California vehicles only
- M-12655-F ProCal 4 delivery tool included
- * Premium fuel required*
- The M-9603-B27 calibration is also available for 2.7L
- For 2021-2024 2.3L Bronco, please see M-9603-B23
Well, that is a significant amount of torque increase over the tune for the 21-24 motor (essentially same HP however). The other tune claimed 385, though the limited amount of dyno and 1/4 runs posted here has me believe 360 ish and 300 ish on 93 octane (or more) is closer to the truth.
Since the rumor around here is that the clutch for MT Bronco's is good for about 400 ftlbs, I wonder if the 25+ motor has an upgraded clutch? If not, Ford feels it is good for more then 400, unless they know they are over rating it is really 390ish![]()
Sponsored
