Sponsored
Not a great image, the mount wasn't the subject, but I do like the mount quite a bit...
I'm using a Scepter Plastic Jerry Can with mine...
I'll get a better pic later to show you!
I'm using a Scepter Plastic Jerry Can with mine...
I'll get a better pic later to show you!
- First Name
- Peter
- Joined
- Dec 3, 2021
- Threads
- 7
- Messages
- 398
- Reaction score
- 676
- Location
- Kingman AZ
- Vehicle(s)
- 2023 Bronco 2Dr - 2022 Bronco Raptor
- Your Bronco Model
- Base
Custom. Two Rotopax 3 gallon jugs. Low profile.
OP
OP
- Thread starter
- #4
I like your set up. I want to keep my spare tire there, though
Custom. Two Rotopax 3 gallon jugs. Low profile.
OP
OP
- Thread starter
- #5
I like that mount. Looks expensiveNot a great image, the mount wasn't the subject, but I do like the mount quite a bit...
I'm using a Scepter Plastic Jerry Can with mine...
I'll get a better pic later to show you!
Sponsored
- First Name
- Bryan
- Joined
- Aug 5, 2021
- Threads
- 41
- Messages
- 5,454
- Reaction score
- 14,501
- Location
- New England
- Vehicle(s)
- Ford Bronco, Escape, Focus
- Your Bronco Model
- Badlands
I currently do not have one... but yes, the RTR Jerry Can mount attaches to the hinge bolts.
- First Name
- James
- Joined
- May 8, 2023
- Threads
- 10
- Messages
- 143
- Reaction score
- 117
- Location
- North texas
- Vehicle(s)
- 23 Bronco Wildtrak
- Your Bronco Model
- Wildtrak
The turn offroad mount is on my Bronco, its great. I'll try to get a pictures soon.
Sponsored
- First Name
- Brian
- Joined
- Dec 5, 2020
- Threads
- 131
- Messages
- 931
- Reaction score
- 2,436
- Location
- Sherwood, OR
- Vehicle(s)
- 2021 Bronco
- Your Bronco Model
- Badlands
Here's a review I did awhile back on the RTR. It's works great and I'd buy another, but it comes with a few issues. Hope this helps!
HammerBuilt rear tailgate brace with optional Rotopax carrier.
- First Name
- Barry
- Joined
- Nov 1, 2021
- Threads
- 14
- Messages
- 2,138
- Reaction score
- 5,378
- Location
- Santa Cruz, Calif.
- Vehicle(s)
- BMW X1, ‘1928 model A, “23 Bronco
- Your Bronco Model
- Big Bend
I also have the hammer built mount…not super sturdy but works fine for few times I may need extra fuel…I use it more for water…can mount two rotopax cans…
I have a RC Tailgate Support already and just took a couple of pieces of 1x1 aluminum and attached them to the hinge bolts and then attached the mount to the aluminum pieces.
Only because I'm in Canada, but compared to the RTR mount, I'm extremely happy!I like that mount. Looks expensive
I had the RC Tailgate Support installed already foir my AAL MASS Platform, so O just took a couple of pieces of scrap 1x1 aluminum and mounted them to the hinge bolts and then mounted the jerry can mount to them...
Sponsored
