- Thread starter
- #391
Frame "clean up".
Had a few significant burrs from crawling, esp down a harder line at Chiva Falls near Tucson. Not this picture, but the harder down line on this same hill.
So got to work with the angle grinder, wire disc and some etching primer just to eliminate work hazards. I guess the right rear lower control arm was mostly cosmetic and rust prevention. Now awaiting my Eastwood black chassis rattle can.
Using it as designed!
Had a few significant burrs from crawling, esp down a harder line at Chiva Falls near Tucson. Not this picture, but the harder down line on this same hill.
So got to work with the angle grinder, wire disc and some etching primer just to eliminate work hazards. I guess the right rear lower control arm was mostly cosmetic and rust prevention. Now awaiting my Eastwood black chassis rattle can.
Using it as designed!
Sponsored
Last edited: