HOSS 3.0 Lift options?

[Carfanatic]

Has anyone just done a leveling kit?

Sponsored

 

[Heckler]

I read somewhere that Eibach is going to make a spring lift for the Hoss 3 Fox shocks, anyone know if this is true and if so is there an ETA on them?

 

[Carfanatic]

so far nothing from eibach.

 

[Heckler]

Bummer…

so far nothing from eibach.

 

[Carfanatic]

i know I was hoping they would make springs for the fox shocks. I am leaving towards just doing a zone level kit.

 

[ronnyek]

I'll get better pictures, but here is my 37s I just installed. Only rubbing was on the steps or running boards. I'll trim or replace those.

 

[adamruiz2001]

I'll get better pictures, but here is my 37s I just installed. Only rubbing was on the steps or running boards. I'll trim or replace those.

Anything done to the suspension?

 

[ronnyek]

Anything done to the suspension?

Yes the rough country 2 or 2.5" lift (seems like it's advertised differently in diff places

 

[adamruiz2001]

Yes the rough country 2 or 2.5" lift (seems like it's advertised differently in diff places

Cool, how you liking it? this is the route I am leaning over collars or springs. Did you install yourself?

 

[ronnyek]

Installed myself. I feel like rc stuff gets a bad rap, but honestly my only beef was the instructions on occasion weren't super clear.

Ride quality is the same as best I can tell. Very pleased with the end result so far

 

[adamruiz2001]

Installed myself. I feel like rc stuff gets a bad rap, but honestly my only beef was the instructions on occasion weren't super clear.

Ride quality is the same as best I can tell. Very pleased with the end result so far

One more question, did you have to do any cutting? Some said they did cutting, some didn't. I am really hoping to just unbolt and bolt, no modification to the ride.

 

[ronnyek]

There is modification you have the make if you have heavy duty bash plates... But it's just making a hole that's there somewhat larger.

No actual irreversible changes to the truck itself. Plates can be replaced so I'm not stressing it. Not sure id replace even if I reverted.

 

[derichio02]

Yes the rough country 2 or 2.5" lift (seems like it's advertised differently in diff places

What was the actual lift height as opposed to the manufacturer advertised height? Not sure if you too measurements before?

 

[NorthTexasBronco]

So they offer 2 different lifts, the non-Sasquatch that is 2 in which i did. it required me to use a spring compressor to clock the front two springs 90 degrees. There is slight contact with the upper control arm at full drop. It did fit 37s with 17x9 -12 with no rubbing that i could tell.

https://www.roughcountry.com/product/ford-lift-kit-40400


Then there is the 2.5 for Sasquatch that doesn't require spring clocking and has upper control arms. Going down this road I would recommend this one if you have the money.

https://www.roughcountry.com/product/ford-bronco-lift-kit-51071

 

[ronnyek]

The 51071 is the one I installed. I'm pretty sure this is advertised as 2.5 but I believe the instructions pages say 2". I don't know how much it actually lifted my bronco, but seemed more like 2.5

Sponsored