Valhalla's Long term build thread

[Valhalla]

wired in

my extrcoil of wire is for when I build the rear winch bumper.

putting out at 38 psi to 4 tires at 0 psi, it took 14 minutes to inflate all 4 to 38 psi

Sponsored

 

[deesle]

@Valhalla ARB sent me the PDF with color photos. Clearly has the washers on the bolts.

 

[Valhalla]

@Valhalla ARB sent me the PDF with color photos. Clearly has the washers on the bolts.

Awesome man! Thanks for sending me this!

 

[deesle]

@Valhalla No worries, here is the full PDF if you need it

 

[Valhalla]

I appreciate it man!!

 

[Valhalla]

I put in my midland 275....

 

[V1Rotate]

I put in my midland 275....

Looks clean! I’m about to do the same.. thanks for the ideas

 

[Valhalla]

It an be a little hard to hear with the speaker below the center trim. I plan to add an external speaker later. I wire it to number 5 on the switches. There are a lot ov video's on removing the trim panels and the dash. Be careful of the pedals when routing the antenna wire.

 

[Valhalla]

I like it this way because it's easy to remove the mic when not on use.

 

[Valhalla]

It's not done, I'll post more once finished and it has a winch.

 

[Valhalla]

I did not like that I could not open my back glass, with the gate closed, with the high lift on. My solution was to buy some cheap eBay JK hood hilift holders.

 

[Valhalla]

These were here when I arrived home from work:

They are crossmember skid plates.... I need this because...

 

[Valhalla]

This

 

[Valhalla]

First straightened these up some.

 

[Valhalla]

Put the piece inside and run through factory holes...

Sponsored