Front leaning to the driver side

[unfortunate]

I have a Sasquatch bronco with the 2.7 v6. I’m wondering if anyone have measured both front fender height on their Bronco? I was looking at doing a leveling kit as the next mod and noticed that my driver side front is 1/2 inch lower than the passenger side? The rears matches though…which is odd.

Sponsored

 

[AK SNO RIDER]

You wouldn't be the first person here to have a random shock failure. Climb underneath.

 

[rtaylor]

Some lean is within spec (0.3"). Not measured at fender. Note full gas tank. Also, be sure you are in 2H and pulled straight into level area before measuring.

Measured here (#2 - #3 on each side).

 

[unfortunate]

Some lean is within spec (0.3"). Not measured at fender. Note full gas tank. Also, be sure you are in 2H and pulled straight into level area before measuring.

Measured here (#2 - #3 on each side).

Thanks! Did the measurements from there. I’m within spec. Though I’m nearly empty. I’ll check again when I get a tank of gas.

 

[unfortunate]

You wouldn't be the first person here to have a random shock failure. Climb underneath.

Visual inspection looks normal. No leaks.

 

[Silver-Bolt]

You wouldn't be the first person here to have a random shock failure. Climb underneath.

Shocks do not support weight. The springs do. A failed shock has no bearing on the ride height.

 

[fiatlux]

OP did you end up getting any resolution to this issue?

 

[unfortunate]

OP did you end up getting any resolution to this issue?

No resolution… I did the measurements someone posted above and it was within spec

Sponsored