Carven Exhaust Dump Exit Kit

[JD155]

Easy install took about 30 minutes including removal of stock exhaust. Sounds great in person. Company was awesome to deal with. Called them w/ a couple questions & very friendly. Even gave me a 12% off discount code. Check them out
https://carvenexhaust.com/products/2021-2023-ford-bronco-2-7l-dump-exit-kit

Sponsored

 

[Bronkers]

Easy install took about minutes including removal of stock exhaust. Sounds great in person. Company was awesome to deal with. Called them w/ a couple questions & very friendly. Even gave me a 12% off discount code. Check them out
https://carvenexhaust.com/products/2021-2023-ford-bronco-2-7l-dump-exit-kit

So the exit point is much further forward/closer to engine? Wish they knew if they had any power gains. See button for 2-door but doesn't seem to work/4-door only...

 

[GI_Jo_Nathan]

So the exit point is much further forward/closer to engine? Wish they knew if they had any power gains. See button for 2-door but doesn't seem to work/4-door only...

Says Pre-Order for 2 door. Wonder when they will be available.

Edit: Never mind I just saw the clip. Sounds great!

 

[Ogre]

Where's the 2.3 love! This is exactly what I've been looking for.

 

[CarGuy]

So the exhaust is being dumped in the middle of the vehicle. Not sure this would pass inspection in NJ. I’d be concerned of some gases entering the cabin.

 

[Vanimalious]

So the exhaust is being dumped in the middle of the vehicle. Not sure this would pass inspection in NJ. I’d be concerned of some gases entering the cabin.

Drive faster to leave gases behind lol

On a more serious note, the bronco isn't even waterproof... Should be plenty of ventilation

 

[CarGuy]

Exactly. But NJ traffic sucks!

 

[Bikeric]

My home-made version dumps in the same spot and I never smell exhaust gases. I tried a shorty resonator type first but hated the sound. I then went with a 2 chamber Flow Monster muffler and it sounds just right (IMO). The muffler was only $40 and the muffler clamp was $15. I cut off a factory hanger and was able to use it to support the rear at a great spot on the frame.

 

[SierraBronco]

My home-made version dumps in the same spot and I never smell exhaust gases. I tried a shorty resonator type first but hated the sound. I then went with a 2 chamber Flow Monster muffler and it sounds just right (IMO). The muffler was only $40 and the muffler clamp was $15. I cut off a factory hanger and was able to use it to support the rear at a great spot on the frame.

You wouldn’t happen to have the part number you used?

Sponsored