- Thread starter
- #1
Can anyone, PLEASE, tell me how to get rid of the seatbelt alert/message on startup in my raptor?? It's a pain in the ass! Thank you!
Sponsored
That’s not the issue. It’s the display that tells you the status of every seat/seatbelt. The display pops up at startup and remains until acknowledged.You can turn the check rear set off in the menus
I can confirm this and for this reason I keep all of my rears buckled all the time when not in use....apparently the banner isn’t persistent if every seat is buckled in, occupied or not.
There is no way to turn it off. I haven’t seen a way in forscan to do it either. I disabled the seatbelt chimes in forscan but it still shows the display with all the seats, it just doesn’t show an “X” over the seats that are occupied without a seatbelt anymore, but just a blank seat. It’s incredibly annoying it does this and if you don’t press “okay” it takes a solid 30 seconds to time out. Been waiting a long time for a solution on this so hopefully someone can come up with it. I have a 5Star tune installed on my Brap and I’m considering asking if he can disable itCan anyone, PLEASE, tell me how to get rid of the seatbelt alert/message on startup in my raptor?? It's a pain in the ass! Thank you!
that does nothing for this issue.Not sure if it's the same for the non-raptors, but I disabled all alerts/alert sounds for the seatbelts using Forscan, double honk when leaving the car when it's on and a few other things. There are other alerts not found in the forum's spreadsheet that you can play around with. Make sure not to mess up ones that you aren't sure of. A laptop running microsoft is required as well as a temporary license for Forscan (free) and a OBD adapter cable to connect the laptop to the car's computer.