Why do people find auto start stop annoying? Honest question, I have it and just ignore it. Does it wear out the battery prematurely?
Sponsored
Why do people find auto start stop annoying? Honest question, I have it and just ignore it. Does it wear out the battery prematurely?
I truly do not even notice it. And I do a lot of city drivingWhy do people find auto start stop annoying? Honest question, I have it and just ignore it. Does it wear out the battery prematurely?
Preference. Just like a soft top or hard top.Why do people find auto start stop annoying? Honest question, I have it and just ignore it. Does it wear out the battery prematurely?
Hood struts was one of the 1st!Mod 27: Orange silicon lug covers - only for the spare.
![]()
Mod 28: Redline Hood QuickLIFTs
![]()
It would be more worthwhile to just get a Forscan, for this price.
Right there with you, yesterday morningWell, rock took out the 2nd windshieldgotta wait until spring and they get all the gravel off the roads before I replace it.
![]()
![]()
Congrats. Looks great! Did you use the BD upfitter harness for the LP6s? Did you use a 10A aux switch for the low beams?Finished my LP6 install along with AMP Power Steps.
![]()
![]()
![]()
![]()
I did use the BD harness. Low beam to Aux 3 and high to Aux 2. Need to still hook up the harness to the battery but was pretty straight forward but way too much wire. Ended up cutting out about 20ft. Only need the 1 amp for high and Aux 2 was the next one available. Any of the switches will work if split.Congrats. Looks great! Did you use the BD upfitter harness for the LP6s? Did you use a 10A aux switch for the low beams?
The low beam spec is for 10A. Just wondering if I should put it on AUX2 for 15A or AUX3 is fine. I have a pair of LP6s and the upfitter harness ready to go. The BD harness has so much more wire than needed. I plan to do the same and eliminate most of it.I did use the BD harness. Low beam to Aux 3 and high to Aux 2. Need to still hook up the harness to the battery but was pretty straight forward but way too much wire. Ended up cutting out about 20ft. Only need the 1 amp for high and Aux 2 was the next one available. Any of the switches will work if split.
10 amps is good for low. No issues so far.The low beam spec is for 10A. Just wondering if I should put it on AUX2 for 15A or AUX3 is fine. I have a pair of LP6s and the upfitter harness ready to go. The BD harness has so much more wire than needed. I plan to do the same and eliminate most of it.
notice a different in the road noise?Installed the Hotheads headliner this morning. Looks to be very good quality. Time will tell. Love the finished look it gives to the interior.
![]()