Trailrax Pak Rax install without removing top?

[Mikem1025]

Anyone ever install the pak rax without taking the top off? Looking for some idea's.

Sponsored

 

[CalvinT]

Anyone ever install the pak rax without taking the top off? Looking for some idea's.

Why look for misery? It's probably possible, but more work unless you don't have someone to help you take the back section off.

 

[Mikem1025]

That is 100% the issue.

 

[Dr Dan]

I just installed mine two weeks ago so the process is pretty fresh in my head. I can't think of a way to get the lower brackets on that the pack rax bolts into without taking the rear clam shell off. There are bolts that need to be exposed which are completely covered by the roof. Once off, install is less than 5 minutes. No neighbor you could bribe with a beer?

 

[Mikem1025]

Everyone is about 20-30 years older than me, I'm 46. I'll figure it out.

 

[CalvinT]

It's been a while since I installed mine, but you may be able to put blocks under each side of the rear section to give you room to work to install the rear brackets. It will be fiddelly but with patience I think it can be done. Just make sure you don't tighten the bolts one one side until you have the bolts started on the other.

 

[ThunderFlash]

I just loosened the bolts on the front of the rack, removed the cab bolts, and jacked my roof up a couple inches using these...

WORKPRO Cabinet Jack Support... https://www.amazon.com/dp/B0CJTJ2F1W?ref=ppx_pop_mob_ap_share

Oh, I took the top front panels off, too. I think that's what I did!? Man, sucks getting old!

Sponsored