Search results

I installed the Borla Catback Sytpe exhaust on my Bronco last year. It had the short climber exit end for more clearance and cheaper price. I loved the sound but since I am in a 2 door the exhaust vents right above the rear axle and you can hear the whoosh when getting on the throttle through...

I was at 2 Walmarts and noticed the large 5 quart jugs of 5w 30 oil are flying off the shelfs! I had to buy the smaller 1 quart jugs because the large jugs were sold out and ended up costing me a bit more for my oil change. Anyone experiencing this in their area? I heard on the news it’s...

Howdy, I am looking at adjusting my clip position on the Front & Back 6112 shocks. I know on the front shocks I will have to remove them, but what about the back shocks? On the back it looks like I can get my spring compressor on there without removing the shocks. Is that a bad idea, Ive...

Howdy, I bought an digital angle finder and looking to check my pinion angle on my 2 Door Bronco. My new upper/lower control arms were installed by a shop and I want to double check their work. According to this chart its set between 0-10 degrees for the operating angle. There is also a note...

Howdy, My Ford Dealer was able to reimburse me about $1800 for my Bilstein 6112s due to my stock Sasquatch shocks leaking and no parts were available at the time of the recall. Which I was pretty grateful for! They however had a heck of time of removing the Bilstein recall from my Bronco...

Story time grab a cold one, Looking for advice on some recent work done on my Bronco. No names used but here the story goes. Where I live any reputable 4x4 shops are over 1 hour drive away. I was going to a decent 4x4 shop but their senior mechanic retired and the new technicians didn’t do as...

I love the stock camera system on my Bronco but looking at adding a underbody camera so I can see where rocks are to avoid getting turtled on my rear differential. Anyone try the Wolfbox and mount it as underbody camera to complement your stock 360 cams?

No this isn’t a grill for your Bronco. Since summer is right around the corner thinking of getting a Kamado grill for my house. Any suggestions? I saw Kamado Joe is popular, Primo and Green Egg. There is even one brand called The Bastard. 🫢. Any recommendations would be appreciated! I...

Anyone running Synergy Control Arms? I just pulled the trigger and will post results once I get them and get chance to use them on trail. Very little information on these for Bronco. Synergy is well known in the Jeep world so surprised not many folks have jumped on them. I went with Synergy...

See press release below. I’m taking my Ranger Raptor to help with carrying fuel and supplies. Several folks may be on ATVs/SxS. Hope to see some more Broncos! Registration here. https://www.sweetwatersnowpokes.com/event-list Celebrate America's 250th: Ride Across WY Hosted by...

Great video on rear control arms. Highly recommend checking out his other videos! Subscribe and give him a shout!

Howdy, For those that have upgraded to a high mount intercooler have you noticed any increases in engine temperatures? I was considering a hidden winch setup from Hammer but I am concerned about causing other issues since the high mount intercooler required for the setup will block portions of...

Well I installed Bilstien 6112's on my Bronco mainly for better performance, more ground clearance, and warranty parts not being available. On a whim I called Ford about getting the recall removed from my Bronco since I no longer had the stock shocks on my vehicle. Ford will be removing the...

Anyone try the B&M diff cover? Looks to be one of the better covers. Has a dip stick, the drain is a bit higher up then the Ford Performance cover so the drain plug won’t be smacked by rocks. Also appears to have enough room for my RCI diff skid. Made in USA. Not sure if it works with the rear...

Howdy, my valve stem has a tiny hole in it and needs replaced. I was thinking of installing one of my spare Colby valve stems. If I pull the old valve stem out will the TPMS still work if I put a Colby Valve stem on it? Or will the TPMS fall into the tire and bounce around until I take it to a...

Need some advice on the install of my Borla Stype Exhaust. Install was fairly simple, exhaust sounds great and has a little extra whomp for butt dyno. Exhaust is also shockingly quite at idle and around town. Only issue I have is the big muffler under my bronco 2 door. It seems awful close to...

Gonna sell my used stock Goodyears locally. They got about 13k miles on them. What’s a reasonable price to sell them? $300?

I don’t know about you but I am on Bronco6g all the time. I thought things would quite down after getting my Bronco and the long 2 year wait. But nope still here. Take the poll.

Got a wild spur and decided to remove the old track bar. Super easy. 2 bolts. I had to put a jack under the passenger side on axle to get the bolt out on the driver side so it didn’t contact the brake lines removing it. Other than that anyone can do this job. Once the new Synergy track bar shows...