Search results

Court date is May 8th. Facebook is my go to for info. It comes up in a few different groups I am in.

37 STT PROs on 8.5 0mm offset. The lift is a 3 inch Icon spacer lift. As you can see it uses every available inch.

This is very easy to damage especially when shipped with the entire locker. 100% should be offered by Ford as a separate repair part. Thought I would post the part number just in case someone else was in your shoes. If that happened to me even under warranty I would have spent the $80 to get...

I accidentally cracked the plastic part of the locker actuator while doing my gear swap. Ford could not find a listing of only the actuator without the actual locker. But spicer sells it . Just an FYI. It was less than $80. Took 3 or 4 days to get.;)

It makes sense. My 70 and 72 both left the factory with no rear seat.

Both pinion bearings were different? My 5.38 FDU should be here soon. Ordered 5.38 JL gears and install kit because we didn't know if there was a difference. We gambled.....and lost. Apparently.

Gotcha. A good parts guy at Ford should be able to find it in the system. A Sasquatch or badlands vin would probably make it easier on him. My replacement will be out of steel if my machinist buddy would get it done.

That seems familiar. Yes the housing is available but back in mid November it was on backorder with no ETA. I am curious how you broke it and tire size.

I promise she isn't the pavement princess that this picture makes you think she is.

100% normal. Relax

The bad part is that I was at on off-road park following a main access road that had a few shallower mud holes proceeding this one. I dropped off into it and within seconds got an alternator fault. 99% of the mud on the truck was me trying to get out after charging system fault and water started...

Thanks👍

Guilty of Alternator death by mud:devilish: Technically it was a mistake. Didn't realize it was so deep until I was in it.

Just learned of this a few hours ago. Interested to see how this plays out.

Who wants to go on a easy ride Saturday November 5th? Plan on meeting at Sylacauga, AL Walmart at 8:00 am and departing 8:30 am to run Talladega National Forest roads 600-1 and 600-2. We will ride most of the day and end around Oxford, AL. There are a few places to bail out if you get tired of...

Who wants to go on a easy ride Saturday November 5th? Plan on meeting at Sylacauga, AL Walmart at 8:00 am and departing 8:30 am to run Talladega National Forest roads 600-1 and 600-2. We will ride most of the day and end around Oxford, AL. There are a few places to bail out if you get tired of...

This Saturday! Any bronco can do this trip. Newbies are welcome. If you are on the fence just do it! Feel free to message me with questions.

They will auto learn within about 1 to 2 miles. You sure the tpms was included?

Who wants to go on a easy ride Saturday November 5th? Plan on meeting at Sylacauga, AL Walmart at 8:00 am and departing 8:30 am to run Talladega National Forest roads 600-1 and 600-2. We will ride most of the day and end around Oxford, AL. There are several places to bail out if you get tired...

Found the same issue back in May. My build date was December 23, 2021. I am well outside the date range listed. So everyone needs to check regardless of build date.