Search results

Congrats. That was a loooong slog. Glad you finally got her.

If one were to look really closely you could probably make out something. You'd have to be looking for it though.

They weaken the plastic in specific spots to allow for airbag deployment, but it should not be visible. That looks like a defect.

https://www.stickerfab.com/products/21-offroad-metal-molle-door-bins-front-and-rear-2021-bronco

I had modified the factory sub and installed a JL Audio 8w3v3. That driver is specified for 250W RMS. Heavily damped the enclosure. It has a nice punch to it. The boomy peak that occurred stock is reduced but it still required a bit of tuning with the DSP to level it out. If interested...

A wise idea. Haven't installed lighting but would do the same.

Check out this thread: https://www.bronco6g.com/forum/threads/mic-hard-top-painted-white-using-raptor-spray-liner-diy-how-to-and-photos.57498/

Almost sounds like a passenger/pet hot car safety feature ...

FORD TSB: Improper trimming of finger nails can lead to interior damage. Customers should be informed to trim their nails, cut their hair, wear a mask, and to take precautions when around vehicle surfaces containing plastic. For on-going protection, do not attempt to look at the plastic. Wear...

I believe that I'd seen a grommet but it may be just as sensible to route it from left to right under/along the dash stuff to the drivers side grommet. The battery is on that side anyhow.

My 2-cents is to wait until you have your Bronco in-hand prior to spending on accessories / upgrades. Unless there's a really good deal :) I had mine for a couple of months and changed my mind on just about everything I was thinking. Oh, I don't need that. Well, that's going to add a lot of...

Hi @gringoloco, I did end-up placing a small bead of black colored plastic compatible epoxy around the entire circumference of the grill as opposed to a couple of spots. Prepped and lightly scuffed up the plastic a bit for adhesion. With small dots, there was some resonance experienced at...

Another option to consider is cosmoline on the underbody. Maybe also for the box frame rails. It is relatively thick and may not self flow into pinch seams or tight locations. A less viscous cavity wax could be more appropriate for some areas. In essence, these are waxes in a solvent that will...

They are not sealed. There is also a cutout directly below each speaker that has a loose and thin foamed plastic plug. Probably acts like a passive radiator. You could probably seal the kick panels with the judicious application of CLD.

I have a mid-23 with the updated amplifier. I agree, it sounded good. Though, it remained a distance from sounding great. I had this debate myself. Coming from an old early 2K Tahoe, this system sounded fine and a definite improvement. It's good enough, I could live with this, I don't really...

Take a look into this, as well: https://www.bronco6g.com/forum/threads/bronco-plug-and-play-1150w-rms-amp-replacement-kit-for-b-o-back-in-stock.79680/ For those with the DSP/sub and harnessing, it is not 100% plug and play but it's close. There is a t-harness at the ACM for the center channel...