Now. It's getting late, but if my rudimentary knowledge of ohms law is valid, dual 4 ohm voice coils= a 2 ohm load to the amp. Dual 2 ohm voice coils=a 1 ohm load to the amp. I have a tough time believing the the factory B&O amp is stable to 1 ohm. That said it seems there are people running...
Thanks, how was the mounting in the factory enclosure. I thought most people were using a dual 4 ohm voice coil? Is the B&O amp stable w/ a 1 amp load?
Thanks
According to the folks at MoBridge they are "working" on a 2025 solution. Among the differences between 21 - 24 & 25 are in 25 "supposedly" EVERY channel goes thru the B&O amp (rear pods and center channel). In 21 - 24 the front dash (minus the center channel) and kicks were amplified thru the...
My '23 Wildtrack did not do this when i started it up. My '24 Raptor displays this every time I start it up, until I press the OK button. I've been thru settings and driver assistance and have not found a setting that turns it off. Is this a "Forscan" mod and if so, does anyone know which...
Ok the Raptor has been getting an upgrade. I previously replaced all 5 of the 4-inch speakers with Infinity 4032's. No Bass blockers we used, just the signal that was coming into the Ford 4 inch speakers. This made a decent improvement in sound quality (more presence / life like / better...
Thank you...
I am beginning to wonder if this will turn into "chasing a snake thru a swamp". No matter what we do, we are working on a Bronco. It is a fairly noisy vehicle, does not compare to the wife's GV70. If that isn't bad enough "most" of what I listen to is 2 track soundboards (dead /...
I just did this less than 2 weeks ago. Wildtrack to Raptor. They are similar BUT different. Before I got the raptor I was worried about the width. After 2 weeks the width is not an issue on the road or in the parking lots (just use a little more care). Had it off road once and it was a...
I have replaced all 5 of the 4-inch speakers in my Raptor with Infinity 4032's. This made a noticeable improvement in sound quality (more presence / life like). It has me thinking that with a decent speaker replacement plan I can possibly get by without the mobridge amp upgrade. As a rule, I...
It is a pain. After 2 torx screws come out and "accessory ready" piece is removes the fun is just beginning. That speaker grill will remove but you'll need some trim tools and patience. I found it easier to work around the grill and pull from the front (where the USB ports are). Then...
I have been searching... :crying:
Has anyone seen a good video of how to remove the center channel speaker? Hopefully a view as to to to get at the recessed area.
I did the other 4 in and hour but am a little perplex as to the best way to get that grill off.
thanks
I'm not comparing, I was amazed and just pointing out they are capable of making some pretty good stuff. Not going to compare a GV70 to a Bronco, and not going to compare any factory premium system to Audison and 1000+ watts of power. The point was these guys make some decent stuff, it would...
A couple of questions; some non specific some raptor specific
Am I correct in assuming you can wax over the vinyl decals (there's more on a raptor that has graphics - but the wild track has a huge on on the hood)?
My plan is 2 coats of the Turtle over the body (minus any plastic areas) and then...
Are the rear pods the same on a wildtrack and a raptor? I have an extra set from my wildtrack and could load them to replace the pods that came in my raptor.
Another question, infinity 407s or 4032s (same specs'4032s are almost 1/2 price) vs hertz dcx. I don't know if I will go the...