Sounds like most of your issues would be solved by getting your dealership to warranty that top. That ain't rightI picked up my 2dr 2024 Big Bend a couple months ago. I thought I saw enough YouTube videos and browsed the forums. I wish I would have read more of these forums in hindsight and relied far less on the YouTube excitement videos. The last ford I had was a 91 probe in high school back around 2001. Since then I have owned Honda, Jeep, Toyota, Subaru, and a couple VWs. Overall they all had some minor quirks or annoyances but nothing prepared me for this Bronco. The last 3 cars I owned were brand new. A Crosstrek, GTI and Tiguan. All looked so nice from the dealership. They ran well and just about everything looked like it hadn't been touched or used yet.
This is just not the case for the bronco, but I'll start with the good.
It is very fun to drive. I even enjoy the engine noise. The steering is perfect. The design of the dash and infotainment is perfect. The overall look and design of the vehicle is fantastic. I love that it has a t-top element that is simple to take down and store. Driving without it is a dream and scratches a bit of that open air itch I've had since selling my motorcycle. The marine grade seats and their design are just right. The seat heaters too! They get to therapeutic levels of hot. And it has a built in subwoofer. Again so many things designed so well!
Another thing I knew going in was that the speakers suck. And they do. But I accepted that going in. I switched them all out with kickers and made some tweaks to the eq, etc and it's actually decent now...As long as you keep it under 40ish mph. You're basically on an airplane going over 70 noise wise.
Now for my issues with this thing.
Im not a fan of the quality and construction of just about everything.
It feels like every day I spot something that just isn't quite right to varying degrees or feels cheap. Everyone has mentioned the plastic inside that is highly prone to scratches. I knew that going in and got canvasback liners for the cargo area plastic, but what I wasn't prepared for was the following..
This is the big one and it has driven me crazy since I noticed it. The top was manufactured in a way that the drivers side sticks out further (isn't flush with the rest of the body)and on the passenger side it is flush and looks correct. It's like they do zero alignment or measurement checks to these things when they leave the factory. I've seen body gap inconsistencies all over but nothing like this. So far no cracks but it does have some of the wavy sheen look I have seen in others. Very light honeycombing pattern as well.
Then I noticed the Drivers side door doesn't close without extra force needed and it just doesn't feel quite right. There's only two doors...and this can't be done right?? The glass annoyingly vibrates when it does latch. (Passenger side operates perfectly)
Then I noticed (and might be related to the above) the hard rubber corner in the front part of of the drivers door (that also channels the glass) has already wore through the rubber weather strip on the receiving side of the door jamb exposing aluminum underneath. My guess is the mold used to make it isn't as accurate in shape as the one used on the passenger side. it has to bend in a weird fashion to close completely. I have seen at least one person post pictures of the same wear shortly after purchase.
![]()
![]()
Sponsored