What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠

[Boreal]

Finished off version 1 of the audio.

Just a temporary solution to get through for a few busy weeks and upcoming trips. The new floor setup will be built in a month or two

Powerbass 4” Waterproof’s up in the dash, I kept ingesting dirt through the pole vents of Kickers and Hertz. Needed a sealed unit.

Kicker CS6.5’s down low. Kicker Key200.4. Plug and Play Harness, Audio Control LC2iPro, Hifonics Brutus 1200.1D Mono, Focal E30KX K2 12” Sub.

Sponsored

 

[BoldNorth]

Deep clean today. Pulled the fenders, clay bar and 303 protectant on fenders and top

What are your running boards?

 

[Local 269 Sparky]

Go Rhino RB20s , very happy with them

 

[Roger123]

Ford points day……I added a mat under my locking box to reduce rubbing and it added a nice spot to hide my dunes flag

We're going to Silver Lake Dunes in MI next month and they require the flag to be on the front of the vehicle. I have a rear mount on my spare tire but am looking for something for the front.

Where/ how do you mount yours?

 

[Beach_Bum]

We're going to Silver Lake Dunes in MI next month and they require the flag to be on the front of the vehicle. I have a rear mount on my spare tire but am looking for something for the front.

Where/ how do you mount yours?

Trail Sight Dune Flag Mount

 

[Rydfree]

Had a great Mother's Day ride with the wife and daughter. Put her up a little dirty.

 

[broadicustomworks]

Saturday was spent in Uwharrie getting dirty with a few good people.
Yesterday the rack bushing was finally installed and transmission fluid and pan were changed out for the RockAuto one with the drain plug.
Hindsight tip:
Take the filler plug out and extract as much as you can. Helps with the mess.
Also the capacity is 13 qts. Doesn’t mean you get all 13 out and put 13 back in with the pan method. I got a little under 6qts out.

 

[Acadist]

We're going to Silver Lake Dunes in MI next month and they require the flag to be on the front of the vehicle. I have a rear mount on my spare tire but am looking for something for the front.

Where/ how do you mount yours?

On the front Swarfworks, found it online, great fit and heavy duty. Look back in the thread, there’s some close ups too

 

[KRAKEN]

Took KRAKEN turkey hunting in southern Tennessee...

 

[G1D1UP]

Took KRAKEN turkey hunting in southern Tennessee...

That Kraken back-ass sits up nice and high. What a cool rig!

 

[Bee Bop]

I got mine from IAG. Haven’t installed them. Directions said you have to remove the soft top. Thats too much trouble… but I do plan on getting a hard top at some point so I figure that’ll be a good time.

You don't have to remove the soft top. you can take out the windows then loosen the hinge bracket in the front and slide it under the top with little trouble.

 

[jzweedyk]

Did some exploring around Hart Draw on the northeast side. Also where it "empties" into the plain that leads down to the Needles district of Canyonlands National Park. Some great overlooks.

 

[Philrod]

Dropped it off to get ExoShield put on the windshield, PPF on the hood and mirrors, and get the windows tinted.

 

[loganelcid]

Added a cargo shelf.

 

[Mattyfly42]

Added some molle panels and mounted some tools and stuff.

Sponsored