What did you do TO / WITH your Bronco today? 👨🏻‍🔧🧰🚿🛠

[STONEWALKER]

A little snow-wheeling @ Holly ORV Park in Michigan

Sponsored

 

[AndGerry]

Went to get the windshield replaced after it cracked yesterday…

 

[Tricky Mike]

Walker Valley ORV

 

[CarbonSteel]

Installed a set of Rockworkx hard top quick install bolts that double as a tie down point.

Nice they had a gray set to match the color (Carbonized Gray).

 

[604Bronco]

Installed a set of Rockworkx hard top quick install bolts that double as a tie down point.

Nice they had a gray set to match the color (Carbonized Gray).

Mine should be arriving on Monday

 

[2door]

Took off the hardtop for the first time this year

 

[604Bronco]

I found a perfect new use for my cup holder…

 

[Fordified1]

Took all tops off for the first time and went on a wildflower / winery / dive-bar cruise in the hill country with friends who have Jeeps.

 

[Ellis Family Garage]

Took Pokey out to Rock Candy Mountain to stretch his legs

Coming down this trail in Baja Mode got a notice that my passenger rear was losing pressure. Found a spot to turn around and found a flat spot to put the spare on

good news, if you were wondering is that the scissor jack did its job perfectly. Bad news is now I’m waiting at the tire shop for the repair. TPMS in the spare did not work correctly, so I will need to check into that but all in all not too bad of a day………

To bad about the flat tire. Love the area been there a few times myself.

 

[Muddog899]

Added some sound deadening to the doors. Huge difference in the sound when they are closed.will do back panels and floors later.

Added some more to the backend of the bronco. Took seats and side panels off. Not sure is I can block the little squares on top off the fender under the window glass.

 

[Razorback]

I'm going in gals and guys...

- Transmission filter and fluid change + PPE deep transmission pan is the main objective today.

-------------------------------------

If time today (if not during the weekend):

- Transfer case fluid change

- Rear axle fluid change (I need to pull my Ford Performance cover to drill and tap for a temperature probe, so I'll reinstall the stock cover temporarily).

- Engine oil and filter change

I will create a detailed post as per usual when completed with the transmission work.

@redone17 + @Dorf2point0

how did the deep pan fit with the skids?

 

[dgorsett]

Added some more to the backend of the bronco. Took seats and side panels off. Not sure is I can block the little squares on top off the fender under the window glass.

I have to remove the passenger side panel for another project, any pointers? Where to start? Tools?

 

[Muddog899]

I have to remove the passenger side panel for another project, any pointers? Where to start? Tools?

Have to remove the cargo cover remove tie downs and back trim panel on the floor then remove the small trim piece by the roll bar. That is a tricky one to get out, then start popping out the rear panel if you have a long panel tool it will help with the clips . I forgot that you also have to pull the trim panel from the door floor area. There is a few you tube videos that explain how to do it.

 

[Beach_Bum]

Went for a swim yesterday.

 

[BroncoNapped]

After a long search and debate, I went with the Steelcraft Fortis rear bumper.

The finish:
Well bulit, I like the rounded look and bulit in license plate. It definitely look like it belongs and not just a bolt on....

The Fit:
Unfortunately the door just barely clears when its fully open. That's after shimming with a washer. I guess I better get one those door restrictors

Sponsored