- First Name
- Rob
- Joined
- Sep 20, 2022
- Threads
- 9
- Messages
- 120
- Reaction score
- 220
- Location
- Central Valley, California
- Vehicle(s)
- 1972 Blazer, 2022 Wildtrak
- Your Bronco Model
- Wildtrak
Based on a quick look at the install manual....no
Sponsored
Sponsored
Based on a quick look at the install manual....no
The Broncos like....ahhhh I haven't used the restroom in a while.
OP
OP
- Thread starter
- #18
Hello my WT 2dr brother. Did you just get yours? Wondering how you have the Hoss 3.0?
No I don't have ours yet. Still on order.
OP
OP
- Thread starter
- #20
Sponsored
Did you have to cut off the tow hooks from the plastic bumper/skid plate mount? You were able to use the plastic skid plate?
- First Name
- Brady
- Joined
- Jul 28, 2020
- Threads
- 2
- Messages
- 102
- Reaction score
- 179
- Location
- Raleigh NC
- Vehicle(s)
- 2019 F-250
- Your Bronco Model
- Outer Banks
Looks great. It would be my first choice if it would accommodate a winch. I am between the DV8 and the LODI. I do think I will put the Havoc rear bumper on though.
- First Name
- Chrome
- Joined
- May 20, 2020
- Threads
- 19
- Messages
- 1,101
- Reaction score
- 2,242
- Location
- The Great Land
- Vehicle(s)
- 2023 2.3L Badlands High, 2017 LWN Duramax Z71
- Your Bronco Model
- Badlands
Tusks worthy of being called a Warthog!Here you go...
If it could hold a winch it'd be perfect for my use.
Gonna paint that 1102 Antimatter Blue? That would be killer.
Last edited:
Those hooks are bolted on.
For the standard bumper the tow rings are part of the inter cooler mount and not bolted on like they are on the modular bumper.
Sponsored
OP
OP
- Thread starter
- #26
That's funny!!! I had the same thought on tusks when it was just loosely mounted. Lol
M1102 - I would like to but I can't get AMB in a hard enamel. Just laid (rolled) the 1st coat of bedliner in the trailer bed. I'm leaning to gloss black. The other trailer came out nice.
OP
OP
- Thread starter
- #27
The loop are are part of the mount for the intercooler.
Glad I did not have to cut them off. The pockets that fit over them stayed installed the the factory skip plate mounted as normal.
One reason I did this bumper is it hides the crash bars from the front and once end caps are installed they maybe hardly noticeable.
OP
OP
- Thread starter
- #28
Both are nice... Garage door clearance was a major factor for me. I would need a hidden (lower) winch an even then not sure I could close the door.
The tusks (tow hooks) have it just inside the door with the door handle in the center. I'm about an inch or 2 away. Crazy!!!!!
- First Name
- Brady
- Joined
- Jul 28, 2020
- Threads
- 2
- Messages
- 102
- Reaction score
- 179
- Location
- Raleigh NC
- Vehicle(s)
- 2019 F-250
- Your Bronco Model
- Outer Banks
Sounds like a good reason to build a new garage
Sponsored
