Vertical Keypad?

[mdfilip]

I purchased from Ford parts but I don't really want to put it on the door or the other locations everyone else is putting them. I want to put in above the door on the B pillar. Anyone have a part number for the vertical keypads vs the horizontal one for the Bronco?

Sponsored

 

[JakeC]

Great question. Do you know IF they made an "attachable" (read: sticky) vertical add-on?

 

[RagnarKon]

Not available.

You may be able to take apart the horizontal one and flip the buttons... but they don't make a wireless RF vertical version.

 

[mdfilip]

Not available.

You may be able to take apart the horizontal one and flip the buttons... but they don't make a wireless RF vertical version.

Thank you very much

 

[MNBigfoot]

Not available.

You may be able to take apart the horizontal one and flip the buttons... but they don't make a wireless RF vertical version.

They don't look square to I doubt they could be flipped. Here is the thread where Raptor Guy removed the cover.
Keypad mounted inside gas door on Bronco Raptor | Bronco6G - 2021+ Ford Bronco & Bronco Raptor Forum, News, Blog & Owners Community

 

[Mike T]

This is where I mounted mine as I also did not want on the door. Black matches the B pillar molding perfect looks like it came from factory this way.

 

[mdfilip]

This is where I mounted mine as I also did not want on the door. Black matches the B pillar molding perfect looks like it came from factory this way.

That is where I was going to put mine but its different on a 2 door not enough room.

 

[Hunterwjusmc]

They don't look square to I doubt they could be flipped. Here is the thread were the guy removed to cover.
Keypad mounted inside gas door on Bronco Raptor | Bronco6G - 2021+ Ford Bronco & Bronco Raptor Forum, News, Blog & Owners Community

The "buttons" are actually a single silicone molded piece over a small pcb (circuit board). You cannot rotate them 90 degrees.

 

[Mike T]

That is where I was going to put mine but its different on a 2 door not enough room.

I did not realize that.

 

[AK SNO RIDER]

This is where I mounted mine as I also did not want on the door. Black matches the B pillar molding perfect looks like it came from factory this way.

That's where I put mine too. It's soo much better than the factory location

Sponsored