Tweeter mounting in A-piller.

[Supp64]

Has anyone successfully mounting a tweeter in the A-piller so that you could run a set of 3-way speakers in the front?

Sponsored

 

[MOBRONCO]

Watching some videos I haven’t seen it done, but it takes working with the airbag to get the a pillar off. Between the defroster vent and airbag seems like a headache.

 

[2020FordRaptor]

Has anyone successfully mounting a tweeter in the A-piller so that you could run a set of 3-way speakers in the front?

It is illegal to be on your cell phone while driving. Tweeting counts as that, Tweeter

 

[MKZoom]

If you have the B&o, you already have a psuedo 3 way as the IP LH speaker is a coax. If you dont have B&o, i think going to a coax is the easiest way to do it.
As others have said, the A pillar has an airbag and the structural sheet metal pillar. id be hesitant to start tearing up stuff there as inhibiting the side air curtain deployment could be dangerous

 

[Hossfire]

Sounds Good did a 3 part video on a high end build they did for Focal. This is part 2. They custom fabbed a 2-way tweeter/ midrange in the left/right dash locations.

 

[Les Korcala]

Watching some videos I haven’t seen it done, but it takes working with the airbag to get the a pillar off. Between the defroster vent and airbag seems like a headache.

I did in my Xterra and was phenomenal sound 600$ set of mid/ twees lots of work sanding forever ! Was it worth it
I say , Yes i used laser to pin point direction from both pairs
In Bronco there is airbag jot sure how much room there is
I just finished nice 3Way mod in my dash fabricating plates for same pair of tweeters and mids

 

[Jorvin]

These are being sold...

https://customspeakerpods.com/store..._ybfdxL70d0Euv8-LUlT345Cf9KS1tSaOVyVyXHaz_5Pl

Sponsored