Charging/Center Console 3D Print STL File?

[JBlanco]

I want to add a charging pad to my base Bronco and want to know if anyone here has an STL file of the charger pad. TIA

Sponsored

 

[smelly]

Manual or automatic transmission? There are some good resources in this thread: https://www.bronco6g.com/forum/thre...harger-install-in-factory-location-diy.32069/

 

[JBlanco]

Manual or automatic transmission? There are some good resources in this thread: https://www.bronco6g.com/forum/thre...harger-install-in-factory-location-diy.32069/

Automatic, thanks for the link, but mine is a base and doesn't have the option of the rectangular removable base below the rubber mat.

 

[smelly]

Automatic, thanks for the link, but mine is a base and doesn't have the option of the rectangular removable base below the rubber mat.

As long as you don't mind hacking up the trim pieces, you could always remove it, 3D print this piece and mark/drill a 2.5" hole in the center with a hole saw:

https://www.thingiverse.com/thing:4936062

 

[WheresMyBronco]

Dang, if I had that piece in my Bronco I'd mock it up for you. Depending on what you need I might be able to make something close enough for you to use

Sponsored