Bronco Team 2 door.

[jzweedyk]

Took it out to Peek-a-Boo canyon just north of Kanab, UT. If you are ever in this area, this is a must see. You take a DEEP sand trail about a mile in with the Bronco. Don't forget to air down. It takes you right to the mouth of the slot canyon. The canyon goes about 1/3 mile in before it dead ends.

Sponsored

 

[Quicklime]

Finally got to put something on the finish of my daughter’s BD. I’ve been using this stuff since 2021. It’s an incredible value at $15 a bottle. It does last a full year if you are busy using your Bronco…

 

[AZ4x4Adventure]

Took a family vacation to Sedona for the weekend from Phoenix. Went and did Broken Arrow. Nice easy trail with beautiful views.

 

[jcgcbns22]

Extreme snow dump in NS Canada. 150 cm+ measured in some locations. 2 weeks back, JCG

 

[jcgcbns22]

Clean up work in progress! JCG

 

[Fizzwoman71]

I am awaiting my 2 door.

 

[Ford Motor Company]

Took a family vacation to Sedona for the weekend from Phoenix. Went and did Broken Arrow. Nice easy trail with beautiful views.

We appreciate you sharing these photos with the community, Jason!

 

[Ford Motor Company]

Took it out to Peek-a-Boo canyon just north of Kanab, UT. If you are ever in this area, this is a must see. You take a DEEP sand trail about a mile in with the Bronco. Don't forget to air down. It takes you right to the mouth of the slot canyon. The canyon goes about 1/3 mile in before it dead ends.

Wow! Thanks for sharing these awesome photos with us, Jim!

 

[Dialtone]

Poser shot at work...

Looks almost like some of the small display just inside the gates at JSC. One time I went there it was locked. Booo.

 

[Dialtone]

I tried that Turtle Wax Ceramic Spray Coating product, and it left my red car with lots of streaks. Mostly visible at an angle when the light reflected. I could not buff them out. Took a lot of time messing around with a damp cloth to cut through and get rid of the smearing. The cuss words were flying. Hard to tell how much product was left after all the work correcting the streaking.

I ended up instead buying some quality carnauba wax ... old school apply, wait until haze, and buff out. Worked great.

Do you have a trick to avoiding streaks with the TW Ceramic Spray?

Streaking issue mentioned here at the 3:56 mark:

Hot surface or too large a working area will streak up pretty quick on you. If wait for a flash and haze it's too lat hot too thick. Dark colors are a real challenge. I've worked the job on my black truck more than once. A wait and reapply can bail you out sometimes or a very fine swirl remover or clay bar. There's a reason a pro charge $$ I'm cheap so I accept screwing up until I get it right a part of the process.

 

[Dialtone]

I tried that Turtle Wax Ceramic Spray Coating product, and it left my red car with lots of streaks. Mostly visible at an angle when the light reflected. I could not buff them out. Took a lot of time messing around with a damp cloth to cut through and get rid of the smearing. The cuss words were flying. Hard to tell how much product was left after all the work correcting the streaking.

I ended up instead buying some quality carnauba wax ... old school apply, wait until haze, and buff out. Worked great.

Do you have a trick to avoiding streaks with the TW Ceramic Spray?

Streaking issue mentioned here at the 3:56 mark:

Good video. I use a battery powered leaf blower for the nooks and crannies to chase out water.

 

[Arokcrwlr]

Looks almost like some of the small display just inside the gates at JSC. One time I went there it was locked. Booo.

This is at MSFC across the street from the building I work in.

 

[Tor148]

Drove over some dirt in my yard.

 

[HeliPilot]

Minor swap. My Bronco came with the stainless entry sill guards. I never liked them. Replaced them with the Badlands guard. I like these much much more.

 

[KRAKEN]

Where did you get those Badlands sill guards?... they look good.

Sponsored