Search results

Search "Razpoy" on Amazon, they make a lot of carbon fiber overlays for our rig, Jeliker makes a steering wheel overlay for the gray part. If you want pics, I have done a lot of carbon fiber overlays. But not the dash itself. I love the white

They will say first service after warranty is over (as everyone does). Do it every 30K minimum, I only use Amsoil ATF and never look back

I assume the front diff has a magnetic drain plug, but not so sure about the TC? If not, anybody have a link to get an aftermarket one? Also, does the rear diff have a permanent magnet inside the cover (like GMs), since it does not have a plug? Thank you

Anyone know the torque spec of this housing?

Just be careful with the Ronin, someone mentioned on FB that they overtightened it and had to replace the oil pan.

After reading the first 6 or 7 pages of the below 36pg thread, I am definitely going with 7qts (I let it drain a long time). Shops rush, so 6 is prob fine when they do it since they don't waste time allowing the last quart to drain out...

Under the radio: usb-c is used to plug my phone in, usb-a is for the AA dongle. It actually takes less time to shut off Sync bluetooth (2 clicks) than to fiddle around with my phone & cable

Even plugged in, I get disconnected often (which makes no sense). Using wireless via the dongle works best for some reason.

I found using an Android Auto wireless dongle works better than using the built-in Sync wireless AA to keep my phone wirelessly connected. But the only way I can get my phone to work through the dongle is to turn off bluetooth on Sync each time I start the car. Is there any way to keep bluetooth...

So 6.5qts is about right?

Thank you for the great info!

I have a '24 non-B&O system with the factory sub & amp swapped out for a Kicker 500.1 amp along with an 8" sub. Before I fire it up, just want to make sure the initial settings & 2 switches are good to go: I assume the input level switch should be set to "LO" (+ & - speaker input wires from the...

Tint shops deal with this all the time with convertibles that do the same thing as our windows. Just have to make sure you heat dry that lower part well before closing the door for the 1st time.

So you didn't use any polyfill & left the port tunnel open at the inlet inside the box & just sealed off the outlet?

I got it for the wife since her Bronco Sport was up on lease. She realized she could never drive it after I became obsessed with the truck while waiting for it to arrive, so it's now my toy and we bought out the lease on the Sport. She claims she will never drive it as she is afraid to wreck...

Besides the Ford Pass & my own spreadsheet, I also update Carfax with any service I perform.

Just rec'd unloaded SSV pods for a 2dr (07/2025) & they are wired backwards. I called the company and they said they never heard that before and asked for pics. A few hours later they did get back to me and confirmed the polarity is backwards! Wonder how many Bronco folks are out of phase with...

I have read here that some stuff the SSV pods to the max, while others use no polyfill? The 6.5" speakers are Rockford Fosgate T1650s & will be programmed in Forscan for full-range (I have a non-B&O system). Subwoofer is upgraded as well to an 8" Kicker w/a Kicker 250W amp. I assume the sub...

So that relay is required because the OEM remote turn-on wire voltage is less that 12V & won't turn on the Kicker amp without the relay?

Don't even notice them, but the wind noise does drown out anything else lol. Just be aware the Toyo OC AT3 12.50s are even lighter than the 1150s due to a thinner sidewall and a lower weight rating. I felt the 11.50s were perfect for my setup with a spacer (I am using 1.25" since I didn't know...