Search results

Oh that's simple. That's not pin 40. That's pin 42 you pluginto. Look one row up on the other side of the connector. It will show 40 And on the other side of the connector you'll a gray wire with a brown stripe. That also could be the reason it won't snap incorrectly

It doesn't look right cuz that's not where the ground wire goes, and it looks like you used a much larger gauge wire than could fit. pin 40 should be for the reverse lights.

If your setup look kinda like this, it should plug in. The terminations are directional and must be orientated in the right direction, fyi

For clearing the code. I wrote all the blocks for the trailer module. (Write all). Then make sure you cycle the (start).

I am out and about this weekend, but the reverse lights come from the other connector C105 just next to the one you wired, pin or position 40. It is middle row on one end ( you can take a picture with you phone. The Connector has pin location on the back edge)

When your done, "Stand back and gaze at your accomplishment!

See pictures below for what I had. It does look like they changed the connection. If you have a meter. I would check continuity between that wires and where it would attach to the trailer module. If you post before this, I attached the wiring diagram for where they come from go to. How this...

I don't understand what you are talking about when you mentioned navigation. Can you clarify?

not for the 7-pin, also the Reverse signal need to be picked up See below diagram: Explanation in words: The trailer control module has 2 fused feeds (fuse 91 and F107 for battery charger) these are both on the same connector (middle connector Module) Connector on left side has your (2) CAN...

(111) DIY Factory Tow Package using OEM parts with Forscan As-built Data (without error codes) | Bronco6G - 2021+ Ford Bronco & Bronco Raptor Forum, News, Blog & Owners Community Also if you click on the number(s) next to the thread counts under my name, it will show you the threads I have...

I did.

Wouldn't be easier to add the factory tow equipment (and a lot cheaper) then selling, and swapping out 1/4 of the dash? I was able to add the tow hitch module, ect, and reprogram it in a weekend. it wasn't terribly difficult.

Double check the Towing, Trailering, Flat-Tow, Hitches forums. There are a few threads on adding it afterwards. I did detail how to add the module and wiring as you would get from the factory.

Update the IPC last it takes (3-4 hours or more) or make sure you know that before you start that module. The abs and chdm modules will still show updates available after they have been updated. ( Even if you do it like 10 times. Apparently that's a known issue. FYI Just did it last weekend...

I'm meeting up with Darrell on Saturday afternoon( post 2:00 p.m.) Location to be determined If you want anything adjusted, just PM me. Will try to get everyone at one time.

I got it all, just shoot me a pm if what you want done.

I am in the Dena, I can probably help you out this weekend if you guys need some help still.

Thanks! On a side note/ Confirmation on others have said/ posted in the past. Yesterday and today I've been updating all the modules using FDRS (I bought a two-day license). I checked my current as built file from the motorcraft website. The trailer control module is part of my vehicles as...

It It does not. That is wpt-1659. look up my thread about hitch install. I have pictures and part number.

Confirm The TRM has the same values as I listed, I doubled check and those where accurate (well they work for me) And when you say "blue" wire what pin are you talking about specifically? I am assuming you are talking about pin 3 on the 7-pin connector. You need to have the brake controller...