Search results

If you have a winch https://www.extremeterrain.com/redrock-4x4-ground-anchor-12000-lb-capacity.html?utm_content=AT Winches - Accessories|RedRock

It looks like the Mickey is 34.5 x 12.8

I removed the BL fender badges and dealer sticker from the gate the minute I got home. I like the clean look, also.

...and people are cracking their tops with the included tool kit. Is there a torque spec for this, anyone?

Ride is just a little bit firmer and more confidence inspiring when you hit bumps in the middle of off camber curves at highway speeds. Most noticeable is the reduction in brake dive. It is a little closer to the experience in my wife's stock Colorado ZR2, although the Bilsteins are not as...

SVC 2" perch collar lift. edit: 1" Titan wheel spacers.

This says it all for me.

285/75-17 will work for sure. Some have reported that 35x11.5 works with that offset and no crashbars.

They had a chance when they reintroduced the current Blazer. Failed miserably.

I've been driving with a crack from one end of the windshield to the other for 6 months. It is just low enough that it doesn't distract me. I'll wait until I get one that is in the way before I replace the glass.

I used Loctite. Twisted on by hand. My mount has a hex base, so removal should be easy.

I bet if you measure the tread, you won't find an inch difference between them. Doesn't GY run narrow. They are heavier because they have a tougher sidewall. 34.76" tall vs 34.4" for GY, if that matters.

What is it with Florida? While vacationing on the Emerald Coast, my wife and I bought a condo. We couldn't take it home, like you did, but we visit it four times a year.

You can turn it off under features

They adjust from flat to 45% down. I don't see a need to adjust left/right with the right pattern.

I'm looking at BluMak for minimal wind noise, minimal hood glare, and minimal view blockage.

For me it was the Bronco logo cargo mat. The cheap mat from Mabett sucks. They took it back, and I'm sure a lot of their other products are great.

https://ruggedridge.com/p/tis-matte-black-556-wheels/tis-556ba-2102819/

Yes, M8 x 1.25mm thread pitch. The item you linked has a 10mm hole for mounting. It should work fine. May rattle when not under load. You may want a plastic or rubber washer behind it to protect the paint on the bar. The rings I use have no moving parts.