Search results

First time smelled this today after remote start in the morning, temperature was below zero Fahrenheit. Has anyone ever figured this out?

First time smelled this today after remote start in the morning, temperature was below zero Fahrenheit. Has anyone ever figured this out?

Thanks for the responses! Just for clarification, I'm asking about the long bracket holding the camera and washer fluid hose. Searching the Ford Part website, each grille design has its own bracket, but the location of bolt holes seems identical. Did you just remove the bracket from your old...

Can Outer Banks' camera bracket be transferred to Raptor grille directly?

Had this the first time today. I did a pretty thorough car wash to clean the salts. While backing into garage I smelled some burning smell. Popped up the hood I saw steam going up from the radiator, which last for about two minutes. At this point I assume it’s just water and hot radiator.

If you mean the auto high beam, yes, that works.

The tool was actually ok, but the plug head was deformed. Good to learn.

Yeah, that might be the reason, my tool is plastic.

Finally got time to install the Alpharex Nova headlight. Dissembling parts was pretty straightforward until the two plastic plugs on the headlight show up, who in the world designed these junk? It took me an hour trying to unplug them using trim tool with no luck, I ended up have to cut the top...

I can feel slight vibration and hum when the transfer case is in 4A, it’s not constant. Don’t know if this is just a Ford thing, will mention this to the dealership in my next service.

I can feel slight vibration and hum when the transfer case is in 4A, it’s not constant. Don’t know if this is just a Ford thing, will mention this to the dealership in my next service.

I can feel slight vibration and hum when the transfer case is in 4A, it’s not constant. Don’t know if this is just a Ford thing, will mention this to the dealership in my next service.

Yes, that external piece is definitely not structural but it seems to be steel as well.

My amber fog lights arrived today and I’m very happy to see them working.

I tested the part with magnet, it’s steel. I will touch up the scratch just in case.

I found a part number, M2SZ-78211A11-AA, looks like the one but the only info I can find is 4lbs weight.

Apparently the drive side A pillar was hit when I put my front hard top back. The scratch looks deeper than just clear coat. Anybody know what that part is made of? If it’s just a plastic cover over the frame, I will just leave the scratch untouched.

Mine is slightly left from center, but it has no problem going straight. The steering wheel also vibrates at 60-65 mph, I had the dealership balance the wheels which reduced the vibration but not fully, don’t know if alignment is also part of the reason for this.

Thank you. Yes, I found a diagnostic protocol for those code in F-150, basically it says if >11V is measured from the two terminals, then replace fog bulb, that’s fair.

I swapped the light control switch and activated the front fog light connectors following the procedure posted here, but I'm still waiting for my fog lights so currently the circuit is open. Just yesterday when I connected forscan for something else I found two codes: B1147:15-48 and...