Search results

start simple and check this fuse

I'll gladly be your guinea pig :wink:wink:

I wonder if this works with GOAT Bronco 4-Door Cage Cross Brace Stiffener because this is pretty sweet

sounds like they are making their customers also their QA, send these free to ppl who are willing to test them at least, 😕 meh

Continuation of https://www.bronco6g.com/forum/threads/new-morimoto-xb-tail-lights-now-available.99542/page-11#post-2618488 Nov-26th Installed 3rd replacement set Nov-27th Experienced hyper-flash Nov-28th Received this reply Nov-28th Tried to ask for another replacement or money back...

For what its worth, this is my technique - I never use a screw driver anymore - pull screw out a bit, using pic tool - use pry tool to pull out screw more if needed - use pry tool to pull out entire clip

not a bad rack, I like it, I'll assume it works with a Heritage top as well?

yup I got the same one but using it for aux switch rewiring

most of the good spots are already taken up 😄 https://www.bronco6g.com/forum/threads/what-did-you-do-to-with-your-bronco-today-%F0%9F%91%A8%F0%9F%8F%BB%E2%80%8D%F0%9F%94%A7%F0%9F%A7%B0%F0%9F%9A%BF%F0%9F%9B%A0.18089/post-2555947...

Thanks for all the feedback, here is a revised diagram changes: - added bus bars - moved 500a fuse so its after the isolator - smaller wire gauge in engine bay No idea where im going to fit the bus bars, but that is a different problem.

Haven't bought the fuses yet, but I have this on my list https://a.co/d/3akno28

I was hoping to not have to pop the hood to turn on the winches, is there a down side to using the aux switch as the cut off?

good stuff thanks for your insights. I was debating on running two fuses at one point, a combination of my diagram and yours. Probably overkill. I didn't think of running a smaller wire size just in engine bay, but it make sense for the shorter wires and gives me options, (because when I start...

Been mulling over this for a while and wanted to get any feedback on this wiring diagram that I came up with I've read a few threads about various winch wiring to the rear and this is the bases of using 2/0 wire to the rear (cost isn't significantly higher) so higher the better is my...

is that a sport? or am I looking at it wrong?

ran air line from engine mounted arb air compressor to rear bumper (no more popping hood to air up)

new bumpers installed with the help of @JawnyBronco barricade tubular bumpers turn off road license plate relocation plate diode dynamics fog lights

same as everyone else

Update: installed new set on Wednesday, everything worked when I tested it, but first drive in 45 degree weather and hyper flash immediately and for the entire drive, no matter how long I held the turn signal on for. Will be sending another email later after I get video of the issue. 😩

I just installed my 3rd replacement set, will report back when I drive it more, I don't expect them to work for very long on non-leds