Search results

I replaced the sunglasses holder with the AUX switch panel on my Bronco. It was tedious but absolutely doable. The following video has all the info you might need for this mod.

You're welcome. The sun glasses holder can be swapped out for the AUX switches. The installation process takes about 2 hours and the grand total for parts is around $800.

Your Bronco didn't come with the wire harness for fog lights, and that makes the process more complicated. If you want to make everything work the OEM-way, through the light switch, you're going to need the factory wire harness. In your case, it would be easier and cheaper to hook up the fog...

Does your Bronco have the front parking sensors?

Your little Bronco looks sweet! You modified it in a tasteful way.

The rims are Raceline Compass 956BS. They're significantly lighter than the Sas wheels.

There are several Carbonized Gray Broncos in my area. IMO this color blends in nicely with the MIC hardtop. I prefer to drive around without it though.

I had had the same issue with the wiper blades that came with the light bar. I don't remember but I think those were 16". I swapped them out for the Bosch 15" blades. No scraping.

Some cows would strongly disagree with this statement.

No need to buy a bunch of beach balls. One of these 9ft. suckers is going to be enough.

I don't have a soft top, sorry.

I have zero issues with V2 housing. The light bar on my Bronco doesn't produce any noise at any speed up to 80+ mph with or without the hard top.

My Bronco had had multiple paint defects. It was repainted under warranty.

Hey Ford, I want this engine under the hood of my Bronco!

Sounds good, thanks.

I added two Velcro straps to the front edge of the Bimini top. They tie down the plastic flap to the striker plates. Before I made this modification, it would flap and make noise at high speeds. The straps solved that issue. I also sewed a Ford patch on top of the Jtops logo and added a...

Those trim panels overlap each other which makes it impossible to skip any steps. You're going to need to follow the instructions shown in the video between 4:45 and 9:45. Don't forget to disconnect the battery ;)

I would buy the BDUSA clips if they didn't have the debossed logo. For this reason, I'm looking for the OEM takeoffs.

WTB Blue OEM vent tabs/ clips