Search results

Goat fab

Thank you Sir. My OCD Thanks you

i knocked over my tray of hardware while working on the rig.I think I found everything but 1 of the bolts that secures the trim over the curtain airbag. It’s probably sitting around in another dimension of time and space with all the 10mm sockets laughing at me. Anyway here are some pics. Again...

First off thank you to everyone on the forum who help blaze the path for the rest of us. In this case DRC was a huge help locating the terminal for the delayed accessory pin. Mountains 2 Metal Under Dash Mount With that out of the way let me celebrate. After struggling where to mount the Yaesu...

AERMTR - sorry about that. I have a 24 Wildtrak. I would be doing front and rear

24 Sas willing to try them out

I just used some 4g Knu Konceptz Kolossos I had laying around. Its all loomed up anyway. It has a red stripe of electrical tape at each end

I made a mount for this.

These were some of the symptoms of my APIM dying in the F350. Warranty replaced, been fine ever since

You guys are the best! Ragnar Kon nailed it in less than a minute.

I managed to lose one of the clips holding the center speaker grill. Anybody know where to get a replacement?

2024 Wildtrax Lux I have a MSD solid state relay that I want to power a few accessories with. Ham radio will be delayed accessory trigger the rest can be run/start triggered. Has anyone been successful installing female terminal kits DU2Z-14474-JA or DU2Z-14474-DA into the BCM Connector 3 as...

Gauge is dependent on ampacity and distance. Unless you’re trying to run a 50” light bar 16 or 18g. should be fine. If you have a longer run maybe 14g. The bigger issue is to use a TXL or GXL wire.

I found mine at Ace. Another idea would be to use a sander and remove the serations

I would think 17#, while over the limit, is within the safety margin but I’m not an engineer. On my F350 paranoia drove me to buy the 3” hitch instead of using a reducer sleeve.

Make sure you DON’T use serrated flange nuts. This can cause erratic conductivity and slew of electrical gremlins. Must be s smooth. NOT LIKE THIS

I held the clutch bracket in place and it looks like there will be plenty of room using that. Very happy as this will save me a ton of console disassembly. With the head removed from the body it will tuck into the Lobo Offroad Overhead mount nicely

Following. On my F350 that spot would fill with ice and snow. Ford had a part to fill that void. Be nice if someone had a similar part for tbe Bronco.

Tye, I do you have the info on the plug to maye with the factory tailgate third brake light? I have Deutsch and Weatherpak kits and TXL wire. I want to make my own harness.

I’m trying to find a place to mount my Yaesu FTM-500 main body in my 24 Wikdtrak. It’s bigger than the Midlands. I tried for an hour behind the glove box no luck. I just got the M2M clutch mount to see if it fits there. For those that have removed the center console how difficult was it?