Search results

Those were the values that weren’t working for me But I must have done something wrong because I redid it and now it works. Perhaps I should delete the thread.

I need a solution to keep the rear seatbelts from fwapping all over the place.

I'm looking to identify where these go. I think I must have mixed up some of them and installed the wrong one somewhere. They're smaller heads than the MIC roof bolts (same heads as the roof rail bolts), but shorter than the roof rail bolts and has a washer. (see the short one)

Those are much larger bolts. These are the same size as the other 6 but shorter and with washers.

I found an assembly drawing online and it shows 8 of the same size bolts - so, now I'm thinking it must be from something else that took those bolts and I used the wrong ones putting some back on/together. Any ideas? The only other thing I remember removing is the MIC top.

My roof rack was factory installed so I have no instructions/schematics. I didn't pay that close attention to the bolts when I first removed it and now I realize there are 2 shorter ones with washers. If it was 4 of them, I would think they secure the rear crossbar but there are only 2. Could...

Which Amazon bags?

very nice

I’ll have to see that. But I’m pretty sure that the rear rack mount points are the center of gravity. I saw someone lift just from that section and it looked pretty stable.

Nice!

Has anyone seen any clever solutions for adding storage at the D-Pillars? Those bolt holes seem like an obvious place to secure/nest some sort of storage box.

Something like this

Do you think those brackets are strong enough to hold even the ~70lbs of the main top?

Everyone seems to agree that using the "lift points" are ok for lifting, but not all agree it's safe for storage - the loads and torque on those areas are significant and not to design requirements. So, what about a wall bracket like a shelf that had pegs to align with the alignment pin and the...

Which lift is that? The only Lange one I've seen requires use of the middle panel.

Do you have a link to the flat hooks you used? I haven't found any that are quite right. I would want to plasti-dip them or something, though.

I'm confused - I talked with Lange about an option that only held up the main body and they said they didn't have one. Do you have link to that version?

This is along the same lines. But instead of strap it’s a bracket. Almost balanced so very little load on front.

Does anyone have photos of the assembly plant? I'd love to see how the factory handles the roof - what attachment point, etc.

I was going to secure the front end (more the middle) of the rail to the front mounting tabs of the roof. Maybe even with a rubber block between.