Search results

I took that apart and all the plugs and cables are good there. I double checked the new wiring for the compressor and it doesn't tap into that wiring harness.

Ok, I also installed a compressor in the tail gate so I'm thinking that's probably it. Not sure why I didn't even consider that. Taking it apart now

Yea that's the one I've been playing with to see if anything is loose but it looks good.

Hello i recent upgraded all my speakers including the sub and my cameras stopped working(backup camera screen black with no lines - camera button below the screen doesn't respond). A few days later they started working and then stopped again. I took apart the rear trim again and looked at the...

Do you have a picture of where your tires sit compared to the fender flares and the UCA? There's so much different information regarding offsets that my head might explode. I thought -12 was the way to go but after reading more everyone says something different so I'm not sure what the best...

Also for those of you like me that are too dumb to read a picture that clearly shows how to wire after the green plug to the amp here you go.

Hey guys I have 1 JL c1-400x. Let me know who needs it! I'll let it go for the cost of shipping.

That'd be sweet! How much are you looking to get out of?

I, unfortunately, did not get the Ford performance one so the choice has been made for me.

I looked into trac bar relocation brackets and I thought they were incompatible with the Eibachs due to frame clearance. The zone uca is very cheap and I see people have put a lot of miles on them so I'll grab that and the max clearance kit.

Hello! I have fallen down the mod mountain. I got the Ford winch kit with points/discount on on Ford's site which led me to looking at lifts to level out the front and make up for lost height. I bought the Eibach 2.0's with HD springs and stumbled on a set of 4 37" c-rated KO2s for $600 on...

Just an update - I sent it! Just picked it up from the dealer yesterday. Eibach 2.0s with the hd springs are coming too.

Hey guys I went deep into the winch rabbit hole and then it occurred to me that the Ford kit is available with the 20% discount and I can apply my points towards the purchase giving this kit an insane value. I can't think of any reason not to do send it - anyone have any negative...

Let's say I don't know much about electronics - what fuse would I need and do you have a recommendation for a distro block?

Thanks for everyone's input in this thread. I just ordered everything to get this setup going. I also ordered the IAG tailgate air compressor kit. Do I need to run the power wires for the rear amp and this air compressor down separate sides of the vehicle?