Sponsored

Bottle Jack Storage Options for In-Floor Cargo Box

jclark

Raptor
Well-Known Member
First Name
Jeanette
Joined
Sep 25, 2022
Threads
25
Messages
242
Reaction score
154
Location
Mid-Michigan
Vehicle(s)
Bronco
Your Bronco Model
Raptor
Clubs
 
I have the DV8 in floor cargo box installed, originally for the additional room. The right size housed my 6 ton bottle jack and accessories and tire repair kit, while the left side had all of my tools in their pouches.

I haven't had a need to use the bottle jack, so all of the parts were still wrapped in their OEM bubble wrap.

I recently needed to clear out that storage box to accommodate the install of a air compressor, and found that the jack had been leaking. According to Safe Jack, storing on its side like I had it is a non issue and it shouldn't have leaked.

But, before I pack it back up to put back in the vehicle after bleeding/servicing/validating it does the job it's supposed to - I'm looking for options for what else I could put it in to both keep it protected and if it leaks again, from getting hydraulic fluid on adjacent gear/surfaces. Is anyone aware of a padded water proof sleeve or bag I can put it in? I don't want a hard case since I jinga its accessories around it in that storage area.

Thanks!
Sponsored

 

CitrusBronco

Everglades
Well-Known Member
First Name
Jim
Joined
May 12, 2024
Threads
26
Messages
1,297
Reaction score
2,635
Location
Citrus county, FL
Vehicle(s)
Former 72 & 73 Bronco driver, f250 7.3 powerstroke
Your Bronco Model
Everglades
Clubs
 
I store mine upright for this reason, but I have had upright jack leak also after bouncing around in my toolbox for over a decade. I use a small tote but you don’t want a tote so I guess get a small dry bag. If it leaks it won’t help you when you need it. I’d store it upright.
 
OP
OP
jclark

jclark

Raptor
Well-Known Member
First Name
Jeanette
Joined
Sep 25, 2022
Threads
25
Messages
242
Reaction score
154
Location
Mid-Michigan
Vehicle(s)
Bronco
Your Bronco Model
Raptor
Clubs
 
I store mine upright for this reason, but I have had upright jack leak also after bouncing around in my toolbox for over a decade. I use a small tote but you don’t want a tote so I guess get a small dry bag. If it leaks it won’t help you when you need it. I’d store it upright.
Upright would be ideal - and I did reach out to SafeJack directly to confirm storage and they indicated there should be no issue storing it on its side - but did suggest doing so with the release on top -

"First up, storing the jack. You are fine to store it on its side. You will just need to make sure that the release value is tightly closed and facing upwards. Storing it this way will eliminate the possibility of this happening again."

I would be fine with a tote would be fine - as long as size-wise it fits in the DV8 in floor cargo storage compartment.
Sponsored

 
 





Top