- Thread starter
- #1
Finally after saving for the past two years, and going back and forth between manufactures, finally ordered a complete set of Dobinsons MRR. Guess I'll have to figure out the adjustments for these things and the height adjustment.
Needed a bit heavier spring in the rear to offset a bit of tongue weight when pulling my off-road camper. Ordered a couple 3/4" sockets for these massive bolts and nuts and got new axle nuts, as I've seen suggested.
Even got one of those hydraulic spring compressors. Not even attempting those clamp one, screw compressor tools (ignore the wire mess in the background.)
Most likely start the install in a month or so. Any tips, suggestions and torque specs for install?
Needed a bit heavier spring in the rear to offset a bit of tongue weight when pulling my off-road camper. Ordered a couple 3/4" sockets for these massive bolts and nuts and got new axle nuts, as I've seen suggested.
Even got one of those hydraulic spring compressors. Not even attempting those clamp one, screw compressor tools (ignore the wire mess in the background.)
Most likely start the install in a month or so. Any tips, suggestions and torque specs for install?
Sponsored
Last edited:
