Replaced my Stinger Tailgate Sub with the JBLFuse in preparation of installing the 2 Door TrailDeck.
Sponsored
Sponsored
What did you do TO / WITH your Bronco today? 👨🏻🔧🧰🚿🛠
Installed1.5 weeks ago put on 275-70/18 Firestone Destination XT and loving them.
Today ordered FP 18" 5 wheel kit, FP door sill covers and hitch plug plus JtopsUSA mesh bimini dual top in tan color.
Mike at Jtops is exceptional. Looking fwd to reduced UV and wind blasting with top down.
- First Name
- Scott
- Joined
- Oct 2, 2025
- Threads
- 9
- Messages
- 190
- Reaction score
- 378
- Location
- Cincinnati, Ohio
- Vehicle(s)
- 2025 Ford Bronco Squatch 2 Door
- Your Bronco Model
- Base
Put the EZ4X4 top lift to good use for the upcoming week of B-E-A-utiful weather. The JTops bimini should help keep the sun from beating down.
My JTops bimini has be sitting in a box in my garage for over a week. The weather here hasn't been cooperating enough to install it.Put the EZ4X4 top lift to good use for the upcoming week of B-E-A-utiful weather. The JTops bimini should help keep the sun from beating down.
My garage is a wreck so I do not have the luxury to pull my Bronco in there.
Sponsored
Didn't happen today, but on Friday the wife's Heritage Edition got lifted and 37s installed. Went with the Zone 2 inch lift, Hankook Dynapro XT, Fuel Sledge 17x9 -12 offset and Rough Country tailgate reinforcement/brake light extension. Wife absolutely loves it!
Finally, installed the Bluetti Charger 2, solar panel, wired up, all seems to be working great. Took her out for a shakedown one night camping trip.
Mounted the Callsun Bifacial 200w solar panel to the top of my FSR Aspen Lite RTT. Used some FSR crossbars made for another tent, modified for my needs. Attached with rivnuts. Tried to keep as low a profile as possible. Ran the solar cable under the front roof rack mount (cut a hole in the rubber seal), along the passenger roll cage channel, to the rear cargo area. Today was an overcast day and was still able to get 30w from it. Yesterday was very sunny and was able to get about 190w.
Installed the Rough Country rear window 2-dr molle panels. Mounted the Bluetti Charger 2 to it. DIY a shelf using the Turn Offroad overhead front molle panel, cut in half, for the Bluetti AC180. So, Charger 2, AC180 and SetPower fridge on slides, all on the passenger rear cargo area. Eventually I'll tuck in all the wires to make it look cleaner.
It all performed the way it should. I needed to get the AC180 up and out of the way to give me more space. Plus the cable overheated when using the rear 12v port. I just didn't trust it. Can't wait to get rolling on some trips this summer.
Mounted the Callsun Bifacial 200w solar panel to the top of my FSR Aspen Lite RTT. Used some FSR crossbars made for another tent, modified for my needs. Attached with rivnuts. Tried to keep as low a profile as possible. Ran the solar cable under the front roof rack mount (cut a hole in the rubber seal), along the passenger roll cage channel, to the rear cargo area. Today was an overcast day and was still able to get 30w from it. Yesterday was very sunny and was able to get about 190w.
Installed the Rough Country rear window 2-dr molle panels. Mounted the Bluetti Charger 2 to it. DIY a shelf using the Turn Offroad overhead front molle panel, cut in half, for the Bluetti AC180. So, Charger 2, AC180 and SetPower fridge on slides, all on the passenger rear cargo area. Eventually I'll tuck in all the wires to make it look cleaner.
It all performed the way it should. I needed to get the AC180 up and out of the way to give me more space. Plus the cable overheated when using the rear 12v port. I just didn't trust it. Can't wait to get rolling on some trips this summer.
- First Name
- Mike
- Joined
- Apr 11, 2026
- Threads
- 2
- Messages
- 11
- Reaction score
- 66
- Location
- Wilmington, DE
- Vehicle(s)
- 2-door 2.7
- Your Bronco Model
- Badlands
Added custom pinstriping courtesy of Allegheny National Forest.
- First Name
- Steve
- Joined
- Dec 7, 2025
- Threads
- 1
- Messages
- 39
- Reaction score
- 123
- Location
- Loudoun County, VA
- Vehicle(s)
- 2025 Ford Bronco, 2000 Audi S4
- Your Bronco Model
- Heritage
A few mods this weekend. One was super easy the other was relatively easy but with bad results.
First up the EZ4x4 4 door hinge alignment pins. Super easy and I was able to remove the doors for the first time
Up next some Bronco Raptor taillights from ebay. This already started out bad by receiving a used pair when it was supposed to be new. The 2nd set I received I gave a go with the install.
And once installed I noticed immediately the passenger side backup light was yellowish and dim. Ugh. Another bad set. These get sent back today and I’ll search for other options.
First up the EZ4x4 4 door hinge alignment pins. Super easy and I was able to remove the doors for the first time
Up next some Bronco Raptor taillights from ebay. This already started out bad by receiving a used pair when it was supposed to be new. The 2nd set I received I gave a go with the install.
And once installed I noticed immediately the passenger side backup light was yellowish and dim. Ugh. Another bad set. These get sent back today and I’ll search for other options.
Sponsored
- First Name
- Bryan
- Joined
- Feb 12, 2024
- Threads
- 0
- Messages
- 29
- Reaction score
- 62
- Location
- Ozark, Alabama
- Vehicle(s)
- 2023 Ford Bronco Base Sasquatch
- Your Bronco Model
- Base
Installed new wheels and tires, replaced the stock sidewiew mirror glass with the Wolf box mirrors, installed new wiper blabes.
- First Name
- Steve
- Joined
- Dec 7, 2025
- Threads
- 1
- Messages
- 39
- Reaction score
- 123
- Location
- Loudoun County, VA
- Vehicle(s)
- 2025 Ford Bronco, 2000 Audi S4
- Your Bronco Model
- Heritage
How did the mirrors turn out? I received mine and was given a refund for the supposed defect. I wanted to install them anyways and see how they were. I found the connector for the blindspot did not seem to work with what I have on my BroncoInstalled new wheels and tires, replaced the stock sidewiew mirror glass with the Wolf box mirrors, installed new wiper blabes.
I was wondering if this part was supposed to come out
- First Name
- Steve
- Joined
- Dec 7, 2025
- Threads
- 1
- Messages
- 39
- Reaction score
- 123
- Location
- Loudoun County, VA
- Vehicle(s)
- 2025 Ford Bronco, 2000 Audi S4
- Your Bronco Model
- Heritage
Great. Glad it worked for you!
- First Name
- Bryan
- Joined
- Feb 12, 2024
- Threads
- 0
- Messages
- 29
- Reaction score
- 62
- Location
- Ozark, Alabama
- Vehicle(s)
- 2023 Ford Bronco Base Sasquatch
- Your Bronco Model
- Base
Mine is a base model sasquatch so nothing fancy about the mirror functions. Just two wires for positioning. They work just like before.How did the mirrors turn out? I received mine and was given a refund for the supposed defect. I wanted to install them anyways and see how they were. I found the connector for the blindspot did not seem to work with what I have on my Bronco
I was wondering if this part was supposed to come out
After the procal tune the other day, i had sport mode enqbled on my Badlands Sasquatch. It makes it a bit more spicy, especially with the tune. I might start researching to see if I can get close to 400hp with some mods.
Sponsored
