- First Name
- Jeff
- Joined
- Jul 7, 2020
- Threads
- 28
- Messages
- 194
- Reaction score
- 152
- Location
- Southeast Florida
- Vehicle(s)
- 2023 Bronco, 2023 Hyundai Santa-Fe, 2019 GT350
- Your Bronco Model
- Outer Banks
- Thread starter
- #1
Liking the look of the three marker lights on the grill. Nothing I found looked right.
I decided to make my own kit. Using these marker lights I found on Amazon, and cut some pieces of left over Mud Flap material used for my gap flaps in the rear.
So I cut the flap material to the width of the marker lights. made a line where I wanted to fold it and placed it in a vice. Used a butane torch to heat the material and a smooth headed hammer to "fold" the material. Even smoothed it out once it sat flat. The material was rugged enough and not so hard as to become brittle and break. I used the marker lights supplied screws to secure them in place. The center just mounted to the plate in the center section of the grille.
Mounted a light to each centered over the B and O (At the ends) screwed them to the inside of the grille with two ten screws each light. Drilled a hole up and made a wiring harness chasing the onboard ones for the Washer and the camera.
At the same time I added a pillar spots, they also had a yellow halo. So I tapped #9 wire on the headlight and ran that up to the wiring for the pods and all done. Wired currently to aux switch #1 for now. My OCD wouldn't let me go to any other.
More photos when the sun goes down.
I decided to make my own kit. Using these marker lights I found on Amazon, and cut some pieces of left over Mud Flap material used for my gap flaps in the rear.
So I cut the flap material to the width of the marker lights. made a line where I wanted to fold it and placed it in a vice. Used a butane torch to heat the material and a smooth headed hammer to "fold" the material. Even smoothed it out once it sat flat. The material was rugged enough and not so hard as to become brittle and break. I used the marker lights supplied screws to secure them in place. The center just mounted to the plate in the center section of the grille.
Mounted a light to each centered over the B and O (At the ends) screwed them to the inside of the grille with two ten screws each light. Drilled a hole up and made a wiring harness chasing the onboard ones for the Washer and the camera.
At the same time I added a pillar spots, they also had a yellow halo. So I tapped #9 wire on the headlight and ran that up to the wiring for the pods and all done. Wired currently to aux switch #1 for now. My OCD wouldn't let me go to any other.
More photos when the sun goes down.
Sponsored
