Sponsored
Razorbak86's latest activity
-
Razorbak86 reacted to Techun's post in the thread Anyone running 35x11.5s on a Sasquatch? Do they look smaller than stock? with
Like.
11.5 is a very wide tire, hardly a true pizza cutter -
Razorbak86 reacted to kodiakisland's post in the thread The 5-tire PERFECT rotation schedule for MAX tread life and value. with Like.
Rotate the same way every time. Don't over think it.
-
Razorbak86 replied to the thread 35x11.5 on a Sasquatch ā Bigger or Smaller? I finally have my answerā¦.Using the term "pizza cutter" in the context of an 11.5" tire width is hilarious! š
-
Razorbak86 reacted to Beach_Bum's post in the thread 35x11.5 on a Sasquatch ā Bigger or Smaller? I finally have my answerā¦ with Like.
It's not that they "lie". But no one should be taking measure from under load. For the OP's case, he was comparing the old/new under...
-
Razorbak86 reacted to Montana Bronco's post in the thread 35x11.5 on a Sasquatch ā Bigger or Smaller? I finally have my answerā¦ with Like.
I think a significant factor in these new tires looking smaller is caused by the white lettering. It draws your vision inward, creating...
-
Razorbak86 reacted to HalfmuleFarmer's post in the thread Bronco Desert Rising Edition Debut (Updated w/ Package Details) with Like.
Iām just always surprised that people here are surprised to discover that not every Bronco variation is aimed at them as the target...
-
No visible damage to any of the three. Not even any hood collapse on the rear bronco where the jeep tire is or the jeep's roof there the...
-
I call BS! AI
-
I can get more torque to the rear wheels by downshifting. I'm not going to be in a hurry if I'm towing a trailer.
-
A 4 cylinder engine doesnāt belong in the Bronco. The base engine should have been the 2.7.
-
Exactly why Ford should have used the 2.7 as the base engine. The 2.3 doesnāt belong in the bronco.
-
Razorbak86 reacted to Herewegoagain's post in the thread My Bronco may be toastā¦ rear ended with Haha.
CONSULT AN ATTORNEY ASAP !
-
Had a great week in North Myrtle Beach with my family. Was on the drive back stopped at a red light in Tennessee and a driver going...
-
Razorbak86 reacted to Felix808's post in the thread 2025 Bronco 2.3L Air Filter Change DIY Write-Up (cabin air filter + engine air filter) with Like.
Great write up. Thanks for the contribution š¤ (y) The 2.7 is the same.
-
Razorbak86 reacted to MilesTeg's post in the thread 2025 Bronco 2.3L Air Filter Change DIY Write-Up (cabin air filter + engine air filter) with Like.
A tip I have from my own misadventure: make sure you use a magnetic screwdriver or other means to secure the bit you use. Or you turn...
-
Razorbak86 reacted to Trash Panda's post in the thread 2025 Bronco 2.3L Air Filter Change DIY Write-Up (cabin air filter + engine air filter) with Like.
Greetings all, I come from the Ranger5G forums and love to do little maintenance write-ups to help people out and save a little money...
-
Razorbak86 reacted to RowsKing's post in the thread A Bronco recovery turns into two recoveries š¤£ with Like.
As a crane operator myself I can speak a little about this. A basic rule of thumb is a 1 to 1 ratio distance to a slope or excavation...
-
Razorbak86 reacted to SierraBronco's post in the thread What's the most "worth it" upgrade you've made to your Bronco? with Haha.
What if my upgrade just causes a lot of problems? š¤
-
Razorbak86 reacted to NeBlackshirts's post in the thread Branson area - Arkansas (Update)___ with Like.
Ok, so have an update on the Branson trip. We ended up on Friday having no dance competition so we took some suggestions from here and... -
Razorbak86 reacted to BreezyNVegas's post in the thread How to Install 5.25" Kicker KSC Speakers in the Factory Pods with Haha.
I bought a used JBL sound bar 4 years ago and haven't looked back since. Literally, I can't see a damn thing out the rear window.
-
Razorbak86 replied to the thread Whaaaat! This hurts. A little..Can confirm. :LOL:
-
Hate is kinda strong, but generally yeah, I donāt like people.
-
I think you should have the cat's looked at regardless to make sure they weren't damaged by the failed engine. They're not exactly a...
-
Why are you guys trying to reinvent the wheel? The recommended psi is on the inside of the drivers door jam. I mean unless you're...
-
-
Razorbak86 replied to the thread Low pressure fuel pump failure - recall.My SYNC 4 Accessory Protocol Interface Module (APIM) also died and had to be replaced. The fuel pump and APIM were both covered under...
-
Razorbak86 replied to the thread Low pressure fuel pump failure - recall.My low pressure fuel pump failed at 2,490 miles on the odometer. My replacement is still going strong at 30,000+ miles. š¤
-
Razorbak86 replied to the thread Engine failure at 45k miles.Ford already replaced the engine. I assume they kept the failed parts for internal examination and disposal.
-
Razorbak86 replied to the thread 1 inch rear sag.Bronco leveling springs and Carolina Squat are practically synonyms on this forum. Maybe you should just replace the rear springs with...
-
Razorbak86 replied to the thread Branson area - Arkansas (Update)___.If youāre willing to drive a bit, there are some scenic sites that are well-known. 1.5 hours SSW is Whitaker Point (Hawksbill Crag), one...
-
Razorbak86 replied to the thread Forscan/FDRS fuel tank size fix for 30.1 gal tank on 2025 Bronco Raptor - has anyone gotten DTE to read correctly?.In the meantime, while awaiting a digital solution, you may want to apply a thin strip of painterās tape to your dashboard fuel level...
-
Razorbak86 replied to the thread 1 inch rear sag.The reason for factory rake is to account for the weight of cargo added to the cargo bay. You āleveledā for an empty cargo bay. Now that...
-
It comes with a 1ā rake from the factory. This is meant to level the Bronco
-
Razorbak86 replied to the thread Engine failure at 45k miles.Sorry to hear of your troubles. Can you post a copy of the service write-up and invoice from the dealerās service department? That will...
-
Razorbak86 reacted to Jdc's post in the thread Ford rehires āgray beardā engineers after AI falls short with Haha.
I heard Ford fired him as a quality checker because he never let anything pass.
-
Razorbak86 reacted to Agr142590's post in the thread Mileage leader: turned 250,000 miles a couple weeks ago. 2022 Bronco Wildtrak w/Hoss 3.0 with Love.
-
Razorbak86 reacted to HeHateMe's post in the thread Mileage leader: turned 250,000 miles a couple weeks ago. 2022 Bronco Wildtrak w/Hoss 3.0 with Haha.
All these damn questions... OP ain't got time to answer... He's driving!
-
Razorbak86 reacted to Ducati1098's post in the thread Mileage leader: turned 250,000 miles a couple weeks ago. 2022 Bronco Wildtrak w/Hoss 3.0 with Like.
No. They just don't have problems like everyone assumes they will.
-
Drive
-
Waiting patiently for one person to agree with the OP that this is less work.šæ
-
doesn't take much to roll the jack around (it's got wheels) š
-
The beauty of the 5 tire rotation is you don't need to use jack stands, unless you just want to stretch out the job so you don't have to...
-
sooo, you have a spare, so lift one wheel at a time replace with spare, lower, lift next, replace with wheel you just took off, repeat...
-
I do mine one at a time. And I jack it up just barely enough to get the tire off, so I don't have to lift the tire to get it on. No jack...
-
Razorbak86 reacted to ThunderFlash's post in the thread Recall 26S35: 2025-2026 Bronco 2.3L Engine Assembly Replacement [May 28, 2026] with Haha.
I have the much more robust and reliable 2.7L, but I'm curious. š In the Ford parts breakdown, is there a part number/name for the 2.3L...
-
Razorbak86 reacted to ThunderFlash's post in the thread Recall 26S35: 2025-2026 Bronco 2.3L Engine Assembly Replacement [May 28, 2026] with Like.
First, poking fun since everyone undeservedly :poop: on the 2.7L in the Bronco, mainly because of one early batch of bad valves from a...
-
Razorbak86 reacted to Ducati1098's post in the thread Recall 26S35: 2025-2026 Bronco 2.3L Engine Assembly Replacement [May 28, 2026] with Like.
Build dates have never been accurate on any Bronco recalls. Build dates really donāt matter, affected actual VINs do. Thereās multiple...
-
Great ... now the oil dealers are going to have ADM over their msrp's. We'll all have to get "reservations" from the Granger Oil...
-
The only thing that's gonna have shelves bare is FOMO panic buying just like ass paper during covid.
-
Razorbak86 replied to the thread Recall 26S35: 2025-2026 Bronco 2.3L Engine Assembly Replacement [May 28, 2026].Fortunately, fuel pumps never fail. š Oh wait! š