Where is everyone mounting their aftermarket amps?

[Wannabe Techie]

thanks!
i have 2 Skar 12’s taking up the whole trunk of my 2 door lol just havent hooked up yet.

Two 12s in the 2 door is going to bump hard. I like it.

Sponsored

 

[mdfilip]

Any of you guys with amps know how I can turn the parking sensor beeps down? I had a amp installed and it's powering the front lower, upper dash speakers and a sub box now the parking sensors are much louder and the touch tones on the radio are also but I can turn that off.

 

[Imsomaha]

Everyone,

I thought I was going to mount my amps under the front seats but that looks like a no go after looking closer. Where is everyone mounting their amps? Thanks!

My guy mounted above glove box behind logo on passenger side dash. 5 channe

Everyone,

I thought I was going to mount my amps under the front seats but that looks like a no go after looking closer. Where is everyone mounting their amps? Thanks!

my installer mounted a fosgate 5 channel above glove box behind the “bronco” on dash

 

[BroncoVegas19]

Got 2 kicker key 500s in there and no problems at all.

Any overheating issues since putting the amps ?

 

[Tomleo67]

anyone mount an amp over the driver side wheel well. is there room behind that panel too?

 

[The Compensator]

Under my seat:

https://stingeroffroad.com/products/ford-bronco-amplifier-bracket

 

[Johnny Mo]

Under my slide out tailgate.

 

[Ft. Worth Rob]

FWIW, my 200.4 Kicker is on the steering column brace and 500.1 Kicker on the Mountains2Metal bracket above glove box. I live in TX where it’s hot and listen to it loud and no heat issues in the year and a half it’s been installed.

 

[HotdogThud]

Mounted mine on the front of my storage box that I built:

 

[2022 base]

I'm assuming no one is worried about water? The rear quarter locations seem the safest aside from inside the dash. I run topless often and have gotten caught in the rain a few times. Under the seats would definitely not be a good option.

Marine Grade Protection / IPX Rating	Amplifiers are ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture. IPX5

 

[mandark]

My guy mounted above glove box behind logo on passenger side dash. 5 channe

my installer mounted a fosgate 5 channel above glove box behind the “bronco” on dash

which fosgate amp?pics?

 

[BroncoByte]

@8oncoPete Looks great! Did you purchase those mounting brackets for the wheel well, or make them yourself? If you purchased them, could you share the name of the manufacturer?

 

[Tye]

Under my slide out tailgate.

how much height is there between the floor and top of slide out tailgate. Im trying to determine If this will work with the amps I want to use.'

 

[Johnny Mo]

how much height is there between the floor and top of slide out tailgate. Im trying to determine If this will work with the amps I want to use.'

Looks like you have 31/4 in of height. My kicker amp is about 2 in. From the back seats to the leading edge of the slide out tailgate when it is fully stowed looks to be about 8 in and width you've got about 35 in

 

[Tye]

Looks like you have 31/4 in of height. My kicker amp is about 2 in. From the back seats to the leading edge of the slide out tailgate when it is fully stowed looks to be about 8 in and width you've got about 35 in

Thank you for this, extremely helpful. What is tje structure like on the underside of the pull put shelf itself. Would i be able to notch it if i needed a little more room for the amps and wiring ?

Sponsored